Abstract:This paper investigates the vibration patterns, i.e. rigid motions of shaft and elastic deformation of support structures, of fan rotor system in aero-engine, which differs from traditional flexible rotor systems, and together with its shaft transverse motions due to unbalanced mass. The fan rotor system commonly is composed of one rigid shaft and two flexible support structures (such as squirrel cages), which is effective to decrease the critical speeds avoiding serious shaft vibration due to unbalance. Scaled test rig for realistic fan rotor system is set up according to similarity principles, governing differential equations of which are deduced by means of Lagrangian approach with four degrees of freedom. In contrast to modeling a traditional flexible rotor system, the system stiffness is not determined by the shaft but the two flexible support structures. The rigid shaft only contributes to the inertial items of the governing equations. Parameter values of dynamic model are identified from measurements on the scaled test rig, the modal shapes and the modal energy distributions are calculated. These modal characteristics of the fan rotor system are quite different from those of a traditional flexible rotor system whose stiffness mainly contributed by its elastic shaft even the system values are consistent. The obtained modal characteristics are compared and confirmed by using the simulation results of a corresponding finite element model, in which shaft is built by rotating beam elements and its flexible structures are built by equivalent spring elements. Campbell diagrams of the fan rotor system are used to illustrate the gyroscopic effect with the increasing speeds. And then the unbalance responses are calculated through the deduced analytical formula rapidly and comparisons, including the response spectrum and orbits, the amplitude and phase frequency response curves, and operating deflection shapes, are carried out in the sub- and super-critical range.

Dynamic Analysis of a Coupled Dual-Rotor With Squeeze Film Damper Considering Sudden Unbalance

Analysis on Influences of Squeeze Film Damper on Vibrations of Rotor System in Aeroengine

Dynamic Behavior Analysis of a Rotor-Bearing-Squeeze Film Damper Coupling System with Bearing Outer Race Localized Defect

Nonlinear vibration response characteristics of a dual-rotor-bearing system with squeeze film damper

Dynamical Behaviors of Hybrid Squeeze Film Damper for Rotor System Vibration Control

ANALYSIS OF THE MULTIPLE-SOLUTION RESPONSE OF A FLEXIBLE ROTOR SUPPORTED ON NON-LINEAR SQUEEZE FILM DAMPERS

Bifurcation Behavior of a Flexible Rotor Supported on Nonlinear Squeeze Film Dampers Without Centralized Springs

Experimental Study on the Vibration Control Capability of a Hybrid Squeeze Film Damper

On the Influences of SFD Acting on the Coupled Dual-rotor System

Double static analysis of multi-rotor system with squeeze film damper

Double Static Analysis of Muti-Rotor System with Squeeze Film Damper

Bifurcation and Chaos of a Bladed Overhung Rotor with Two Disks Supported on a Centralized Squeeze Film Damper

Influence of width of squeeze film damper on the transient response of rotor systems

Dynamic Behavior Analysis of Intermediate Bearing-Squeeze Film Dampers-Rotor System under Constant Maneuvering Overload

Nonlinear dynamic of turbulent bearing-rotor system under quadratic damping with HSFD and active control

Bifurcation and Chaos of the Bladed Overhang Rotor System with Squeeze Film Dampers

Vibration response analysis of rotor system coupled with a novel 4-DOF SFD hydrodynamic model considering the influence of rotational displacement

A modeling method for a rotor system with an active floating ring squeeze film damper

Influence of Structural Damping on Stability of the Rotor System

The effect of squeeze film damper parameters on the unbalance response and stability of a flexible rotor

Modal characteristics and unbalance responses of fan rotor system with flexible support structures in aero-engine