Abstract:This paper presents a bridged contactless measurement technique that can measure the resonant frequency and quality factor of a fully-integrated powered off voltage-controlled oscillator (VCO). Unlike the use of the conventional two-coil inductive link, the proposed technique uses an additional inductor to bridge the coupling between the LC tank and the external inductor serving measurement purposes. This makes it possible to examine the on-chip high frequency oscillator with an off-chip inductor at Printed Circuit Board (PCB) level. As an example, a K-band VCO as well as the proposed test structure have been designed and simulated using 0.13 μm CMOS technology. The quality factor and operating frequency of the oscillator are measured using the proposed contactless technique through extraction from the frequency response of a bridged inductive link. The efficiency of the method has been validated by full wave electromagnetic simulation. As a reference, the characterization of the oscillator is also obtained using the Cadence Spectre RF and Mentor Graphic's Calibre PEX commercial Electronic Design Automation (EDA) software. The results of these two solutions agree considerably well, which supports the feasibility and potentials of using this technique for contactless measurements.

Virtual Frequency Characteristic Test Instrument Covered Mobile Communication Band

Frequency Characteristics Test Methods Based on Virtual Instruments

Research of automatic control system for ultralow frequency vibration calibration

The Design of the Virtual Testing System of Vehicle Vibration Based on VR

Testing System of Characteristics of Electrical Vibration Table

Cavity Beam Position Monitor Test System Based on Virtual Instrument

Instrument Driver for Signal-Oreinted ATS

Intellectualized and Integrated Testing System Exploration of FM Broadcasting Transmitter

Design and implantation of high frequency radio frequency identification reader virtual instrumentation system

Study on the Virtual Testing Platform of Vehicle Vibration Based on VR

Design of a Household ECG Based on Virtual Instrument Technology

Based on the SystemView FIR low-pass digital filter experimental design and analysis

A Bridged Contactless Measurement Technique for LC Tank Based Voltage-Controlled Oscillator.

Circuit Testing and Diagnosing System Based on Virtual Instrument Technique

Virtual Instrument Based On VEE For Video Signal Test

Design and Implementation of Virtual Test System Based on LabWindows/CVI

Design and realization of ultrasonic testing system based on virtual instrument

Research on the virtual instrument-based integrated test system for aircraft electrical power system

Development of a Virtual Lab for EMC Application

An efficient testing system and calibration method for a reflection type vector modulator

Design of MultiChannel Parallel Dynamic Testing Virtual Instrument Based on Dynamic Measurement