Abstract:In advanced technology nodes, large timing margins must be added to allow for worse process, voltage, temperature, and aging variations. The error detection and correction (EDAC) technique effectively eliminates these margins by timing speculation, but the high design complexity and large hardware cost make many existing EDAC systems unsuitable for commercial processors. Based on the instruction-level locality of timing errors, a collaborative EDAC approach is proposed to address this issue. The hardware layer adopts simple and low cost EDAC circuits to ensure correct operation when timing error occurs, while a runtime software layer prevents recurring errors of the same instruction by sending timing error alarms to the hardware layer. Cooperation of both layers, accompanied with the proposed profile-guided timing error avoidance algorithm, eliminates more than 95% of errors with small runtime overhead. This significantly improves overall performance and alleviates pressure on the EDAC circuits. Experimental results based on the three-stage commercial CK802 processor in SMIC 40LL process present that the approach has improved the peak performance of the baseline EDAC system (Razor-Lite + half-frequency replay) by 8% and reduced the energy consumption by 25%, with less than 1.4% area overhead.

Joint Equalization Technique and Special Spacing Rules for Link Design

SPIRAL: Signal-Power Integrity Co-Analysis for High-Speed Inter-Chiplet Serial Links Validation

A Compact Passive Equalizer Design for Differential Channels in TSV-Based 3-D ICs

Equalization with Neural Network Circuitry for High-Speed Signal Link

A High Efficient CTLE for 12.5 Gbps Receiver of JESD204B Standard

Equalization techniques for high-speed serial interconnect transceivers

Co-design of 40Gb/s equalizers for wireline transceiver in 65nm CMOS technology

An Optoelectronic Joint Equalization Scheme Based on Photonic Reservoir Computing and TDNN for CD and Nonlinearity Compensation in IM/DD Link

A Highly-Scalable Analog Equalizer Using a Tunable and Current-Reusable for 10-Gb/s I/O Links

Noise Analysis and Transmission Coding Optimization for High-speed Interconnection

Eliminating Timing Errors Through Collaborative Design to Maximize the Throughput

Electronic Equalization of Intrachannel Nonlinearities

Low Complexity Joint Neural Network Equalizer in a 248 Gbit/s VSB PS-PAM8 IM/DD Transmission System

Joint Network-Channel Coding with Rateless Code over Multiple Access Relay System.

Joint Network-Channel Coding with Rateless Code in Two-Way Relay Systems

A 3.75gbps Configurable Continuous Time Linear Equalizer and 3-Tap Decision Feedback Equalizer in 65nm Cmos

A 40gb/s Adaptive Equalizer with Amplitude Approaching Technique in 65nm Cmos

Bandwidth Allocation Approach for Network-on-Chip Based on Contention Probability

Design and ASIC Realization of High Speed Equalization Combining Carrier Recovery

Lateral Asynchronous and Vertical Synchronous 3D Network on Chip with Double Pumped Vertical Links.

Virtual Channel Number Effect and Clock Ratio Effect for a Network-on-chip