Abstract:This article presents some results dealing with effects of atomizer types on mean droplet size and pulse detonation engine (PDE) performance. The plain-orifice injector and twin-fluid air-assist atomizer were located at the head-end of a PDE mockup to inject gasoline, which was used as the liquid fuel. A particle size meter based on laser light scattering was employed to measure mean droplet size. The curves of mean droplet size versus gasoline flux and gasoline/air ratio are obtained. The twin-fluid air-assist atomizer can produce much smaller mean droplet size than the plain-orifice injector. The air was injected into the mixing chamber through tangential ports that gave the fuel a high angular velocity, thereby creating smaller droplets. To observe the effect of gasoline droplet size on PDE, the proof-of-principle experiments of PDE were carried out. The experimental results indicated that the equivalence ratio lower limits decreased and the upper limits increased as the gasoline droplet size decreased when air-assist atomizer was used instead of plain-orifice injector. That meant the equivalence ratio limits turned wide as the gasoline droplet size decreased. Meanwhile, the optimum equivalence ratio decreased as the gasoline droplet size decreased. The smaller the droplet size, the lower the optimum equivalence ratio required to stabilize detonation. As the operation frequency increased, the equivalence ratio limit became narrow and the difference of optimum equivalence ratio between the air-assist atomizer and the plain-orifice injector decreased. Furthermore, droplet size of liquid fuel had a considerable effect on the wave speed. The wave speed increased as the gasoline droplet size decreased, while still being lower than the gas-phase Chapman-Jouguet detonation velocity.

Ignition-Detonation Performance of Pulse Detonation Engines

Direct-connected Experimental Investigation on a Pulse Detonation Engine

Experimental Investigations on Detonability Limits of Pulse Detonation Rocket Engine

Effects of Parameters of Turbulence Generator on the Detonation Wave in Air-Breathing Gasoline-Air Pulse Detonation Engine

Ignition method effect on detonation initiation characteristics in a pulse detonation engine

The effect of operating frequency and ignition energy on JP-10/PO/aluminum powder multiphase-pulse-detonation-engine

Numerical Investigation on Effects of Ignition Energy on Two-phase Detonation Wave Formation

Experimental Study of Atomization Effects on Two-Phase Pulse Detonation Engines

Investigation of the Effects of Inlet Type on Pulse Detonation Engine Resistance Characteristics

Investigation on Combined Aero-Valve of Air-Breathing Gasoline-Air Pulse Denotation Engine

Numerical investigation of flame propagation and performance of obstructed pulse detonation engine with variation of hydrogen and air

The Method to Compute and Analyze the Performance of the Pulse Detonation Engine

Analysis on impulse characteristics of pulse detonation engine with nozzles

Numerical Studies of Pre-Detonator Ignition of Pulse Detonation Engine

Experimental Investigation on Thrust Augmentation of Pulsed Detonation Engine(PDE)

Numerical Investigation on New Engine Combustion Charactristic of Helicopter

Influence of Aerodynamic Valve Structural Parameters on Detonation initiation and Back Pressure Characteristics of Air-Breathing Pulse Detonation Engine

Experimental study of an air-breathing pulse detonation engine ejector

One Inducing Factor of the Operational Mode Transition in A Rotating Detonation Engine

Effects of Fuel-Supply Position on Detonation Waves and Working Frequency in an Aero-Valve Pulse Detonation Engine

Effects of Aerovalve Structure on Performance of PDE