Abstract:This article presents some results dealing with effects of atomizer types on mean droplet size and pulse detonation engine (PDE) performance. The plain-orifice injector and twin-fluid air-assist atomizer were located at the head-end of a PDE mockup to inject gasoline, which was used as the liquid fuel. A particle size meter based on laser light scattering was employed to measure mean droplet size. The curves of mean droplet size versus gasoline flux and gasoline/air ratio are obtained. The twin-fluid air-assist atomizer can produce much smaller mean droplet size than the plain-orifice injector. The air was injected into the mixing chamber through tangential ports that gave the fuel a high angular velocity, thereby creating smaller droplets. To observe the effect of gasoline droplet size on PDE, the proof-of-principle experiments of PDE were carried out. The experimental results indicated that the equivalence ratio lower limits decreased and the upper limits increased as the gasoline droplet size decreased when air-assist atomizer was used instead of plain-orifice injector. That meant the equivalence ratio limits turned wide as the gasoline droplet size decreased. Meanwhile, the optimum equivalence ratio decreased as the gasoline droplet size decreased. The smaller the droplet size, the lower the optimum equivalence ratio required to stabilize detonation. As the operation frequency increased, the equivalence ratio limit became narrow and the difference of optimum equivalence ratio between the air-assist atomizer and the plain-orifice injector decreased. Furthermore, droplet size of liquid fuel had a considerable effect on the wave speed. The wave speed increased as the gasoline droplet size decreased, while still being lower than the gas-phase Chapman-Jouguet detonation velocity.

Experimental study of an air-breathing pulse detonation engine ejector

Experimental Investigation on Thrust Augmentation of Pulsed Detonation Engine(PDE)

Experimental Investigation of the Performance and Spray Characteristics of a Supersonic Two-Phase Flow Ejector with Different Structures

Analysis on impulse characteristics of pulse detonation engine with nozzles

Experimental and Numerical Analysis of Supersonic Air Ejector

Direct-connected Experimental Investigation on a Pulse Detonation Engine

Experimental Research of the Performance and Pressure Gain in Continuous Detonation Engines with Aerospike Nozzles

Phenomenological Aerodynamic Analysis of an Ejector Exposed to Large Inlet Pulsations

Exploring Feasibility of Missile's Employment of Air-Breathing Two-Phase PDE (Pulse Detonation Engine)

Experimental and numerical investigation of two phase ejector performance with the water injected into the induced flow

Numerical Study of the Effect of MHD Accelerator Technology on the Thrust Augmentation in Pulse Detonation Engine

Numerical studies on detonation wave in hydrogen-fueled pulse detonation combustor with shrouded ejector

Structural Optimization and Experimental Investigation of Supersonic Ejectors for Boosting Low Pressure Natural Gas

Experimental Investigation of a Cylindrical Air-Breathing Continuous Rotating Detonation Engine with Different Nozzle Throat Diameters

The effect of operating frequency and ignition energy on JP-10/PO/aluminum powder multiphase-pulse-detonation-engine

Design and experimental study on whirl aero-valve for pulse detonation engine

Investigation on Combined Aero-Valve of Air-Breathing Gasoline-Air Pulse Denotation Engine

Continuous Detonation Engine and Effects of Different Types of Nozzle on Its Propulsion Performance

Micro Turbojet Engine Nozzle Ejector Impact on the Acoustic Emission, Trust Force and Fuel Consumption Analysis

Initiation of an upstream propagating detonation wave near the open end of the detonation tube operating in the valveless and purgeless scheme

Experimental Study of Atomization Effects on Two-Phase Pulse Detonation Engines