Preparation of Acrylonitrile Polymer/Nanometer Silica Composite Particles by In-Situ Emulsion Polymerization

Wenting Zhao,Yongzhong Bao,Zhiming Huang
DOI: https://doi.org/10.3969/j.issn.1001-7631.2009.06.012
2009-01-01
Abstract:Acrylonitrile-methyl methacrylate (AN-MMA) copolymer/nanometer silica composite particles were synthesized by in-situ emulsion polymerization in the presence of nanometer silica absorbed with 2,2'-azobis (2-amidinopropane) dinydrochloride (AIBA). The effects of AIBA concentration and reaction temperature on the kinetics of in-situ emulsion polymerization of AN-MM, and the effects of content of SiO2 on the particle size distribution and morphology of composite particles were investigated. It was found that the conversion of AN and MMA increased with the increase of AIBA concentration and temperature,and the polymerization rate of in-situ emulsion was lower than that of the conventional emulsion polymerization at the same AIBA concentration. The average size of AN-MMA copolymer/silica composite particles increased with the incease of the content of silica in monomers. The AN-MMA copolymer/silica composite particles exhibited rough surfaces, and nanometer silica particles were combined well with latex particles when mass fraction of silica was 10%, and a part of silica particles were separated from the latex particles and located at the water phase when mass fraction of silica was 20% and 30%, respectively.
What problem does this paper attempt to address?