Abstract:Autothermal reforming (ATR) of methane is a promising technology for low-carbon H2 production due to its high CO2 capture efficiency (>95 %) and cost advantage. Especially, reforming CO2+CH4 greenhouse gases to valuable CO+H2 gases is a feasible solution for carbon-neutral energy systems. Flame temperature, reforming gas composition and concentration, and soot loading are major factors determining the efficiency of H2 production in the subsequent catalyst region. In this study, the effects of CO2/CH4 ratio on the profiles of temperature, OH radical, light gas products, large polycyclic aromatic hydrocarbons (PAHs), and soot were investigated for CH4-CO2-O2 laminar inverse diffusion flames near ATR conditions, using the combined non-intrusive and intrusive diagnostic methods. Pure O2 as oxidizer was fed through the central nozzle of the burner surrounded by CH4 fuel diluted with CO2. The experimental results revealed that the formation of soot and PAHs was greatly suppressed with a higher CO2/CH4 ratio. The PAHs and soot loading followed exponential function as CO2/CH4 mole ratio, regardless of pressure, O2 mole fraction, and burner size. The flame height was found to increase linearly with CO2 dilution, and the high temperature region (> 1000 K) shifts downstream. The H2 production decreased with CO2/CH4 ratio, while CO production is less sensitive to CO2 dilution. The importance of radical species during soot formation is confirmed based on the comprehensive data set. Moreover, five well-known chemical-kinetic mechanisms were evaluated against experimental datasets. The comparisons indicate that the flame temperature and concentration trends of investigated species are well predicted, but future work is needed to improve the prediction accuracy of amplitude and spatial distribution, especially for C2H2, PAHs and soot. The reported experiment and simulation results can provide valuable guidance for ATR model validation, development, reduction, and application.

Experimental Researches on Flammable Gas Generator of Kerosene with Catalytic Reforming Reaction

Conversion of emulsified kerosene in a gas generator with catalytic reforming

Experimental Researches on Catalytic Reforming Gas into Scramjet Model Engine

Kinetic Study of Reactive Sorption-Enhanced Reforming of Coke Oven Gas for Hydrogen Production

Characterization of CH4-CO2-O2 Diffusion Flames Near Autothermal Reforming Condition

Experimental Study on Ignition of Pre-Mixed Gases with Steam under Catalytic Reforming Reaction

Experimental study on catalytic ignition

Coke Suppression of Kerosene by Wall Catalytic Steam Reforming

Interaction Between Thermal Cracking and Steam Reforming Reactions of Aviation Kerosene

Numerical Study of Fluid Flows and Heat Transfer of Aviation Kerosene with Consideration of Fuel Pyrolysis and Surface Coking at Supercritical Pressures

Experimental study of hydrogen catalytic combustion wall temperature distribution characteristics and its effect on the coupling performance of autothermal reformers

Influence of Catalytic Reforming Reaction for Premixed Gases with H2 on Flame Propagation Velocity

Heat Sink and Conversion of Catalytic Steam Reforming for Hydrocarbon Fuel

Experimental Study of Ignition Behaviors of Pyrolysis Gas of Kerosene‐based Endothermic Hydrocarbon Fuel

Use of Catalytic Reforming to Aid Natural Gas HCCI Combustion in Engines: Experimental and Modelling Results of Open-Loop Fuel Reforming

Numerical Simulation and Experimental Investigation of Diesel Fuel Reforming over a Pt / CeO 2-Al 2 O 3 Catalyst

Experimental Research on Natural Gas HCCI with Closed-Loop Fuel Reforming

An Analysis of the Ignition of Premixed Gases by a Hot Spherical Surface with Catalytic Reforming Reaction☆

Mechanisms And Applications Of Catalytic Combustion Of Natural Gas

Experimental study on catalytic ignition ofn-C4H10/H2/air mixtures

Heat Transfer and Thermal Cracking Behavior of Hydrocarbon Fuel