Abstract:Ammonia (NH3) has shown promise as a carbon-neutral fuel, and blending NH3 with methane (CH4) can improve its combustion characteristics. This study investigated the auto-ignition characteristics and kinetic modeling of NH3/CH4 mixtures using a rapid compression machine (RCM). Ignition delay times were measured under various conditions, including three different NH3/CH4 ratios, pressures of 15 and 25 bar, temperatures ranging from 910 to 1272 K, and equivalence ratios of 0.5 and 1.0. The results showed the addition of CH4 significantly promoted NH3 ignition. An intriguing phenomenon of pre-ignition pressure rise was noted in blends containing 25 % CH4, which cannot be replicated by previous models. Time-resolved species measurements were conducted using a fast sampling system coupled with gas chromatography. The measurements revealed distinct early consumption of CH4 compared to NH3 in blends exhibiting pre-ignition pressure rise. A kinetic model was developed for NH3/CH4 combustion with emphasis on key “CN” reaction pathways constrained by experimental results. Sensitivity and reaction path analyses highlighted the significance of these “CN” reactions in determining the varying ignition characteristics. Additional simulations systematically assessed factors influencing auto-ignition behavior in NH3/CH4 mixtures. Notably, CH4 concentration emerged as the primary parameter affecting the ignition behavior. Lower CH4 concentrations led to NH3 chemistry primarily controlling the overall ignition process, which could cause early CH4 oxidation and potential gradual pre-ignition pressure rise. Conversely, higher CH4 content facilitated its oxidation to trigger the oxidation of NH3, thereby narrowing the time gap between the initiation of consumption for the two fuels.

Experimental study on catalytic ignition

Experimental Study on Ignition of Pre-Mixed Gases with Steam under Catalytic Reforming Reaction

Numerical Investigation of Diesel Spray Combustion Characteristics in the Ammonia/air Atmosphere

Combustion of Premixed Ammonia and Air Initiated by Spark- Ignited Micro-gasoline-jet in a Constant Volume Combustible Vessel

Experimental study on catalytic ignition ofn-C4H10/H2/air mixtures

A Study on Effect of a Small Amount of Hydrogen Content on Ignition of Flammable Premixture

The Influence of a Catalytic Reforming Reaction on the Ignition of Diesel Oil Mixed with Water

An Analysis of the Ignition of Premixed Gases by a Hot Spherical Surface with Catalytic Reforming Reaction☆

Experiment Study on Catalytic Ignition of n-Butane/Air Mixtures in the Micro-reactor

Hydrogen-assisted catalytic ignition characteristics of different fuels

Experimental Researches on Catalytic Reforming Gas into Scramjet Model Engine

Ignition Process Study of Emulsified Fuel's Catalytic Reforming Reaction

Transition Between Thermal and Chemical Effect of Hydrogen Assisted N-Butane Fuel Catalytic Ignition over Pt Catalyst

Visualization study on the ignition and combustion characteristics of methane/hydrogen ignited by diesel

Influence of Catalytic Reforming Reaction for Premixed Gases with H2 on Flame Propagation Velocity

Experimental Study of Ignition Behaviors of Pyrolysis Gas of Kerosene‐based Endothermic Hydrocarbon Fuel

Experimental and Kinetic Investigations of the Effect of H2/CH4/C2H4 Addition on the Burning Properties of Practical Jet Fuel

Investigating Auto-Ignition Characteristics and Kinetic Modeling of NH3/CH4 Mixtures Using an RCM

Thermal and Chemical Effects of Hydrogen in Catalytic Ignition of N-Butane/air Mixture

Combustion characteristics of n-heptane spray combustion in a low temperature reform gas/air environment

Experimental Study on the Time Evolutions of Methane Reburning and Combustion Process