Abstract:Dimethyl ether (DME) is a highly reactive diesel substitute that can be used as a pilot fuel to ignite low- reactivity methane (CH4) in heavy-duty engines. To optimize the efficiency and emissions of CH4/DME dual-fuel engines, it is crucial to study the fundamental combustion characteristics of DME mixed with methane. This study focuses on the influence of CH4 addition on the low-temperature oxidation (LTO) preparation stage and the thermal ignition (TI) preparation stage of DME in the two-stage ignition process, as these two stages respectively control the ignition delay of the first and second stages. The comparison is made between pure DME and a 50% CH4 and 50% DME blended fuel, operating under thermodynamic conditions representing the engine in- cylinder environment at 30 atm pressure, 650K temperature, and a stoichiometric equivalence ratio. The results show that the addition of methane hardly affects the control mechanism of the two-stage ignition of DME. Specifically, the LTO preparation stage is still promoted by the increase in OH radicals in the DME’s low-temperature oxygenation pathways to form KET, and the second stage is still controlled by the H2O2 loop mechanism. The kinetic analysis also reveals that methane addition can compete for some of the OH radicals in the LTO preparation stage, which has a suppressing effect on ignition. However, in the TI preparation stage, methane can promote the loop reaction of OH→HO2→H2O2→OH and promote ignition. For the operating conditions studied here, although methane consumes a total of 7.24% prior to thermal ignition, it only consumes 0.63% of the total amount in the LTO preparation stage and 1.81% of the total amount in the TI preparation stage. This indicates that methane is mainly consumed in the LTO stage, accounting for 65% of the total methane consumption amount. It can be concluded that the kinetic effect of methane has a relatively small impact on the ignition delay of the DME, at least for the conditions investigated here. In other words, the dilution and thermal effects caused by adding methane are the main reasons for the prolonged time of LTO/TI preparation. Overall, more fundamental research is warranted to understand the role of methane in the two-stage ignition process of DME, which could facilitate the development of CH4/DME dual-fuel engines.

The Influence of a Catalytic Reforming Reaction on the Ignition of Diesel Oil Mixed with Water

Numerical Investigation of Diesel Spray Combustion Characteristics in the Ammonia/air Atmosphere

Ignition Process Study of Emulsified Fuel's Catalytic Reforming Reaction

Experimental study on catalytic ignition

Numerical Study on the Effect of Wall Catalytic Reform on Combustion of Emulsified Fuel with Water

The Study on Preparation and Combustion of Diesel-Methanol Micro-Emulsified Fuel

Experimental Study on Ignition of Pre-Mixed Gases with Steam under Catalytic Reforming Reaction

STUDY ON THE MECHANISM OF SAVING FUEL CONSUMPTION FOR EMULSIFIED FUEL WITH WALL CATALYTIC REFORMING REACTION

A Theoretical Study On Cool Flame Oxidation As An Effective Way For Fuel Reforming: Emphasis On Ignition Characteristics And Chemical Analysis

A Study on Ignition Characteristics of Emulsified Oil Containing Flammable Fuel

An Analysis of the Ignition of Premixed Gases by a Hot Spherical Surface with Catalytic Reforming Reaction☆

The Effect of Methane Addition on the Low-Temperature Oxidation Preparation and the Thermal Ignition Preparation of Dimethyl Ether under Representative Engine In-Cylinder Thermal Conditions

Coke Suppression of Kerosene by Wall Catalytic Steam Reforming

Influence of Catalytic Reforming Reaction for Premixed Gases with H2 on Flame Propagation Velocity

Chemical kinetics of ignition timing of diesel engine fueled with water emulsion diesel

Theoretical study on the effect of low-temperature reforming on gasoline compression ignition (GCI) at low-load conditions

Water Impact on the Auto-Ignition of Kerosene/air Mixtures under Combustor Relevant Conditions

Study on Process of Autothermal Reforming of Diesel to Hydrogen

Experimental study on catalytic ignition ofn-C4H10/H2/air mixtures

Study of Exhaust Gas Composition and Dilution Effects on Diesel Spray Ignition Characteristics

Numerical Simulation and Experimental Investigation of Diesel Fuel Reforming over a Pt / CeO 2-Al 2 O 3 Catalyst