Abstract:The ejector refrigeration system (ERS) using zeotropic mixtures obtains better performance and lower refrigeration temperature than that of the ERS using pure refrigerants, and the characteristics of the zeotropic mixture ejector are a theoretical basis for its optimal design. However, there are few literatures on the performance mechanism of the zeotropic mixture ejector. From the perspective of the binary zeotropic mixture, the R32/R245fa ejector model is developed in this paper based on computational fluid dynamics (CFD) theory, and an experimental setup is also built to validate the CFD model of the ejector. Firstly, the mixing process characteristics of two streams with different composition ratios entering the ejector are investigated, and the key parameters affecting the mixing process are evaluated. Secondly, the impact of zeotropic mixture composition ratio on the ejector's performance is analyzed in terms of entrainment ratio, velocity distribution, and pressure distribution. Finally, aiming at the entrainment ratio, a performance comparison between the R32/R245fa ejector and the pure refrigerant R245fa ejector is conducted under various primary stream conditions, yielding the optimal composition ratio range for the mixture when the R32/R245fa ejector outperforms the R245fa ejector. The findings demonstrate that the R32 mass fraction in both the primary and secondary streams significantly influences the performance of the R32/R245fa ejector. The composition distribution inside the ejector is primarily influenced by the shock chain. The optimal entrainment ratio is achieved by selecting an appropriate R32 mass fraction in the primary stream, and increasing the R32 mass fraction in the secondary stream leads to a linear enhancement in the entrainment ratio. Moreover, when the R32 mass fraction in the primary stream falls within the range of 0-0.08, the entrainment ratio of the R32/R245fa ejector surpasses that of the R245fa ejector operating in the critical mode. Furthermore, this advantage becomes more pronounced as the R245fa ejector gradually deviates from the critical mode.

Experimental validation of a hybrid ejector model with refrigerant R141B

Experimental Investigations on A R134a Ejector Applied in A Refrigeration System

Theoretical Study on A Novel R32 Refrigeration Cycle with A Two-Stage Suction Ejector

Experimental investigation on two-phase driven ejector performance in a novel ejector enhanced refrigeration system

Energy and exergy analysis of a new ejector enhanced auto-cascade refrigeration cycle

A full operating conditions ejector model for refrigeration systems driven by low-grade heat sources

A Comparative Study on Regulation Methods for Transcritical CO2 Ejector Expansion Refrigeration System.

Investigating the Thermal-Hydraulic Performance of New Refrigerant Mixtures Through Numerical Simulation of Minichannel and Microchannel Evaporators

Theoretical Study of A Transcritical Ejector Refrigeration Cycle with Refrigerant R143a

1D Model to Predict Ejector Performance at Critical and Subcritical Operation in the Refrigeration System

Zeotropic mixture ejector: modeling approach, validation, and assessment based on composition ratio

Mathematical Model and Experimental Validation for Mass Entrainment Ratio of Ejector System with Single Phase R744

Development of Control Model for Critical Operation Ejector

Experimental and modeling studies of thermally-driven subcritical and transcritical ejector refrigeration systems

Simplified Ejector Model for Control and Optimization

Analysis on the Optimal Mixing Pressure and Efficiency Limit of an Ideal Ejector

A 1D model to predict ejector performance at critical and sub-critical operational regimes

Numerical investigation in effects of refrigerants' thermodynamic properties on performance of supersonic ejector

Theoretical analysis of ejector refrigeration system performance under overall modes

Progress of mathematical modeling on ejectors

A 1D Model to Predict Ejector Performance at Critical and Sub-Critical Operational Regimesmodèle Unidimensionnel Utilisé Pour Prévoir La Performance D'un Éjecteur Sous Des Conditions De Fonctionnement Critiques Et Sous-Critiques