Abstract:Effective charging techniques must consider factors such as charging efficiency, lifecycle, charging time (CT), and battery temperature. Currently, most charging strategies primarily focus on CT and charging losses (CL), overlooking the crucial influence of battery temperature on battery life. Therefore, this study proposes a constant temperature–constant voltage (CT-CV) charging method based on minimizing energy losses. The charging process is primarily divided into three stages. In the first stage, a constant current (CC) charging is implemented using a 2C rate that aims to expedite battery charging but may result in a rapid temperature increase. The second stage involves constant temperature charging, where the charging current is regulated based on battery temperature feedback using a PID controller to maintain a stable battery temperature. The third stage is constant voltage (CV) charging, where a fixed current is applied continuously until the current drops below the charging cutoff current. After completion of the charging process, the charging time can be calculated, and charging losses can be determined by incorporating the battery equivalent circuit model (ECM). To determine the optimal transition time, the paper employs Coulomb counting and the battery ECM, considering both CT and losses to simulate the transition time with minimal CL. This approach achieves optimization of transition points by establishing ECM, measuring internal impedance of the battery, and simulating various charging scenarios, and eliminates the need for multiple actual experiments. Experimental results show that the charging time (CT) should be reduced and the maximum temperature rise (TR) should be reduced under the same average TR condition of the proposed method. At the same CT, the average TR and the maximum TR should both decrease. The charging method proposed in this study exhibits the following advantages: (1) simultaneous consideration of the battery's equivalent circuit model and charging time; (2) the achieved transition point demonstrates characteristics of minimized charging losses; (3) eliminates the need for multiple experimental iterations.

Design and Implementation of Li-ion Battery Charger IC Based on Constant-Current/constant-voltage Approach

Chip Design of Li-Ion Battery Charger Operating in Constant-Current/Constant-Voltage Modes

Design and implementation of a multifunctional management chip for multi-cell Li-ion batteries in series

Analysis and Design of Wireless Charging Systems Without Extra Components for Load-Independent Constant Current and Voltage Battery Charging

Fast charge circuit for lithium battery based on DSP control

Analysis and Design of Linear Li-Ion Battery Charger

Bi-directional On-Board Charger Architecture and Control for Achieving Ultra-High Efficiency with Wide Battery Voltage Range

A Low-Power Voltage Reference Source for Lithium Battery Protection ICs

Analysis and Design of an IPT System Based on Shunt Inductor Compensation for Battery Charging Applications.

Li-ion Battery Charging Controller Based on Interruptible Constant Voltage-Constant Current Algorithm

Battery Charger Controller IC Based on BCD Technology

Implementation of Constant Temperature–Constant Voltage Charging Method with Energy Loss Minimization for Lithium-Ion Batteries

Design of Valve Regulated Lead-Acid Battery Charger Controller Integrated Circuit

Experiment-Based Determination of Optimal Parameters in Constant Temperature–Constant Voltage Charging Technique for Lithium-Ion Batteries Using Taguchi Method

Evaluation of Charging Methods for Lithium-Ion Batteries

Optimization of Multi-Stage Constant Current Charging Pattern Based on Taguchi Method for Li-Ion Battery

Searching for the optimal current pattern based on grey wolf optimizer and equivalent circuit model of Li-ion batteries

PSO-based Optimization for Constant-Current Charging Pattern for Li-Ion Battery

High efficiency multi power source control constant current/constant voltage charger lithium-ion battery based on the buck converter

Design of a novel ultra-capacitor constant power charger

Li-Ion Battery Charger with Smooth-Switch-Over Four-Stage Control