Abstract:High pressure can significantly increase the densification. Further, during the high pressure assisted sintering, the nucleation rate is increased due to reduced energy barrier and the growth rate is suppressed due to the decreased diffusivity. Thus high pressure enables the specimen to be fabricated with relatively lower temperature and shorter sintering period that assures to obtain dense nanocrystalline ceramics. Dense nanocrystalline BaTiO3 ceramics with uniform grain sizes of 60 and 30 nm, respectively, were obtained by pressure assisted sintering. The crystal structure and phase transitions were investigated by Raman scattering at temperatures ranging from -190 to 200 degrees C. The Raman results indicated that the evolution of Raman spectrum with grain size is characterized by an intensity decrease, a broadening of the line width, a frequency shift, and the disappearance of the Raman mode. With increasing temperature, similar to 3 mm BaTiO3 normal ceramics, the successive phase transitions from rhombohedral to orthorhombic, orthorhombic to tetragonal, and tetragonal to cubic were also observed in nanocrystalline BaTiO3 ceramics. In addition, when particle size is reduced to the nanoscale, one will find some unusual physical proper-ties in nanocrystalline ceramics, compared with those of coarse-grained BaTiO3 ceramics. The different coexistences of multiphase were found at different temperature. Especially, the ferroelectric tetragonal and orthorhombic phase can coexist at room temperature in nanocrystalline BaTiO3 ceramics. The phenomenon can be explained by the internal stress. The coexistences of different ferroelectric phases at room temperature indicate that the critical grain size for the disappearance of ferroelectricity in nanocrystalline BaTiO3 ceramics fabricated by pressure assisted sintering is below 30 nm

Phase Transition And Dielectric Properties Of Nanograin Batio(3) Ceramic Under High Pressure

Dielectric Properties of Fine-Grained Batio3 Ceramics under High Pressure

The Effects of High Pressure on the Ferroelectric Properties of Nano-Batio3 Ceramics

High Pressure in Situ Differential Thermal Analysis of Na0.5Bi0.5TiO3 Phase Transitions Up to 5 GPa

ChemInform Abstract: High Pressure in Situ Differential Thermal Analysis of Na0.5Bi0.5TiO3 Phase Transitions Up to 5 GPa.

Dielectric Properties of BaTiO3 Ceramics Sintered by High-pressure Approaches

Pressure-Induced Phase Transition in BaTiO 3 Nanocrystals

The Phase Transitions and Ferroelectric Behavior of Dense Nanocrystalline BaTiO 3 Ceramics Fabricated by Pressure Assisted Sintering

Phase Transition And Dielectric Properties Of Pbla(Zr,Sn,Ti)O-3 Antiferroelectric Ceramics Under Hydrostatic Pressure

Raman Studies of Nanocrystalline Batio3 Ceramics

Phase Transition and Dielectric Properties of Pbla(Zr,Sn,Ti)O-3 Antiferroelectric Ceramics under External Field

Phase Transition and High Dielectric Constant of Bulk Dense Nanograin Barium Titanate Ceramics

High pressure Raman studies of dense nanocrystalline BaTiO 3 ceramic

Phase Transition in PbTiO3 under Pressure Studied by the First-Principles Method

Hydrostatic Pressure and Temperature Induced Phase Transition and Dielectric Properties of La-Doped Pb (zr, Sn, Ti) O-3 Antiferroelectric Ceramics

Pressure Tuned Ferroelectric Reentrance in Nano-Batio3 Ceramics

Influence of Hydrostatic Pressure on Electric Field Induced Phase Transition of Pbla(Zr,Sn,Ti)O-3 Ceramic

Investigation of Phase Transition in PZT95/5-Nb Ceramics under Hydrostatic Pressure

Study on the Dielectric Properties of 0.75Pb（mg1/3nb2/3）o3-0.25Pbtio3 Ceramic under Hydrostatic Pressure

Properties of Pressure-Induced Phase Transition in Nb-doped PZST Ceramics

Influences of External Fields on Dielectric Properties and Phase Transition of Pbnb(Zrsn,Ti)O-3 Antiferroelectric Ceramics