Abstract:High pressure can significantly increase the densification. Further, during the high pressure assisted sintering, the nucleation rate is increased due to reduced energy barrier and the growth rate is suppressed due to the decreased diffusivity. Thus high pressure enables the specimen to be fabricated with relatively lower temperature and shorter sintering period that assures to obtain dense nanocrystalline ceramics. Dense nanocrystalline BaTiO3 ceramics with uniform grain sizes of 60 and 30 nm, respectively, were obtained by pressure assisted sintering. The crystal structure and phase transitions were investigated by Raman scattering at temperatures ranging from -190 to 200 degrees C. The Raman results indicated that the evolution of Raman spectrum with grain size is characterized by an intensity decrease, a broadening of the line width, a frequency shift, and the disappearance of the Raman mode. With increasing temperature, similar to 3 mm BaTiO3 normal ceramics, the successive phase transitions from rhombohedral to orthorhombic, orthorhombic to tetragonal, and tetragonal to cubic were also observed in nanocrystalline BaTiO3 ceramics. In addition, when particle size is reduced to the nanoscale, one will find some unusual physical proper-ties in nanocrystalline ceramics, compared with those of coarse-grained BaTiO3 ceramics. The different coexistences of multiphase were found at different temperature. Especially, the ferroelectric tetragonal and orthorhombic phase can coexist at room temperature in nanocrystalline BaTiO3 ceramics. The phenomenon can be explained by the internal stress. The coexistences of different ferroelectric phases at room temperature indicate that the critical grain size for the disappearance of ferroelectricity in nanocrystalline BaTiO3 ceramics fabricated by pressure assisted sintering is below 30 nm

Pressure-Induced Phase Transition in BaTiO 3 Nanocrystals

High Pressure in Situ Differential Thermal Analysis of Na0.5Bi0.5TiO3 Phase Transitions Up to 5 GPa

ChemInform Abstract: High Pressure in Situ Differential Thermal Analysis of Na0.5Bi0.5TiO3 Phase Transitions Up to 5 GPa.

Phase Transitions in Nanoparticles of BaTiO3 As Functions of Temperature and Pressure

Phase Transition in PbTiO3 under Pressure Studied by the First-Principles Method

In Situ Phase Transition Study of Nano- and Coarse-Grained Tio(2) under High Pressure/Temperature Conditions

Pressure-induced structural transition in CaF2 nanocrystals

Pressure and Temperature-Dependent Optical Properties of TiTa2O7

Pressure‐induced phase transition and elastic properties of TiO2 polymorphs

Pressure-induced phase transition and elastic properties of TiO<sub>2</sub>polymorphs

Raman Studies of Nanocrystalline Batio3 Ceramics

The Phase Transitions and Ferroelectric Behavior of Dense Nanocrystalline BaTiO 3 Ceramics Fabricated by Pressure Assisted Sintering

High pressure Raman studies of dense nanocrystalline BaTiO 3 ceramic

Pressure-induced amorphization and polyamorphism in one-dimensional single crystal TiO2 nanomaterials

Phase Transition And Dielectric Properties Of Nanograin Batio(3) Ceramic Under High Pressure

Influence of pressure on the kinetics of ferroelectric phase transition in BaTiO3

Structure and properties of a quasi-one-dimensional compound BaTiS3 under pressure

Study on phase transition of SrTiO3 by in situ impedance measurement under high pressure

Phase Transition In Batio3 Nanotube Arrays

Isostructural phase transition in Tb2Ti2O7 under pressure and temperature: Insights from synchrotron X-ray diffraction

Investigations of the phase transition in nanocrystalline Pb1-xLaxTiO3 system