Abstract:A method for the determination of trace levels of silicon from biological materials by inductively coupled plasma mass spectrometry (ICP-MS) has been developed. The volatility of water-soluble silicon species, hexafluorosilicic acid (H2SiF6), and sodium metasilicate (Na2SiO3) was investigated by evaporating respective solutions (50 μg/mL silicon) in HNO3), nitric acid + hydrochloric acid (HNO3 + HCl), and nitric acid + hydrochloric acid + hydrofluoric acid (HNO3 + HCl + HF) at 120 °C on a hot-block to near dryness. The loss of silicon from H2SiF6 solutions was substantial (>99%) regardless of the digestion medium. Losses were also substantial (>98%) for metasilicate solutions heated in HNO3 + HCl + HF, while no significant loss occurred in HNO3 or HNO3 + HCl. These results show that H2SiF6 species were highly volatile and potential losses could confound accuracy at trace level determinations by ICP-MS if digestates prepared in HF are heated to eliminate HF. Among the various matrices comprising major elements, sodium appeared to be effective in reducing silicon loss from H2SiF6 solutions. Excess sodium chloride (NaCl) matrix provided better stability, improving silicon recoveries by up to about 80% in evaporated HF digestates of soil and mine waste samples, but losses could not be fully prevented. To safely remove excess acids and circumvent the adverse effects of excess HF (e.g., risk of high Si background signals), a two-step digestion scheme was adopted for the preparation of biological samples containing trace silicon levels. A closed-vessel digestion was performed either in 4 mL of concentrated HNO3 and 1 mL of concentrated HCl or 4 mL of concentrated HNO3, 1 mL of concentrated HCl and 1 mL of concentrated HClO4 on a hot plate at 140 °C. Digestates were then evaporated to incipient dryness at 120 °C to remove the acids. A second closed-vessel digestion was carried out to dissolve silicates in 0.5 mL of concentrated HNO3 and 0.5 mL of concentrated HF at 130 °C. After digestion, digestates were diluted to 10 mL. The solution containing about 5% HNO3 and 5% HF was directly analyzed by ICP-MS equipped with an HF-inert sample introduction system. The limit of detection was about 110 μg/L for 28Si when using the Kinetic Energy Discrimination (KED) mode. The method was used to determine silicon in various plant and tissue certified reference materials. Data were acquired for 28Si using KED and standard (STD) modes, and 74Ge and 103Rh as internal standard elements. There was not any significant difference between the accuracy and precision of the results obtained with 74Ge and 103Rh within the same measurement mode. Precision, calculated as relative standard deviation for four replicate analyses, varied from 5.3 (tomato leaves) to 21% (peach leaves) for plant and from 2.2 (oyster tissue) to 33% (bovine liver) for tissue SRM/CRMs. Poor precision was attributed to material heterogeneity and the large particle size distribution. An analysis of lung tissue samples from those with occupational exposure to silica dust revealed that tissues possessed substantial levels of water-soluble silicates, but the most silicon was present in the particulate matter fraction.

Volatilization and determination of monatomic silicon in industrial silicon

A High-Efficiency and Energy-Saving Method for Purifying Industrial Silicon for Silicone Use

Effects of solidification rate on the leaching behavior of metallic impurities in metallurgical grade silicon

Comparative study on removal of metallurgical silicon impurities by different acid leaching methods

Silicon extraction from x-ray amorphous soil constituents: a method comparison of alkaline extracting agents

Influence of Iron, Aluminum, Calcium, Titanium and Vanadium Impurities Removal from Silicon Based on Cu-catalyzed Chemical Leaching

Determination of Trace Silicon in Nickel Sulfate Solution by Solvent Extraction

Trace Silicon Determination in Biological Samples by Inductively Coupled Plasma Mass Spectrometry (ICP-MS): Insight into the Volatility of Silicon Species in Hydrofluoric Acid Digests for Optimal Sample Preparation and Introduction to ICP-MS

Study on the extraction and separation of trace silicon from sodium molybdate solution with iso-amyl alcohol

Separating and Recycling of Elemental Silicon from Wasted Industrial Silicon Slag

Removal of Impurities from Metallurgical Grade Silicon During Ga-Si Solvent Refining

Enhancing the separation of Fe/Al/Ca impurities from metallurgical silicon to purify by slagging-directional solidification

A Novel Method of Purifying Metallurgical-Grade Silicon Using Mn As an Impurity Trapping Agent

Efficient Recovery of Silicon from Silicon Slag by Interface Modification Combined with Flotation

Trace Organic Silicon Analysis Using Atomic Absorption Spectroscopy

Analysis Pollutant Production and Discharge in high-purity polysilicon industry of solar cell

Determination of trace silicon by flow injection/differential kinetic chemiluminescence method

Extraction of sodium metasilicate from fly ash to Al2O3 production wastewater

Effect of Silicon Separation on the Preparation of High-Purity Aluminum

Assessment of silicon purification possibility by chemical vapor transport reaction with zinc sulfide

Study of the Preparation of High Purity Silicon by a New Electro-thermal Metallurgy Method