Abstract:In order to improve the cleanliness of steel, non-aluminum deoxidation processes have begun to replace aluminum deoxidation processes. Although the aluminum deoxidation process can reduce the oxygen content in steel to <10 × 10−6, this deoxidation method causes fatigue failure resulting from the formation of large-grained spherical (Ds-type) inclusions composed of calcium–aluminate. It also tends to lead to nozzle blockage during casting. Given the above problems, this study conducted an in-depth investigation of silicon–manganese deoxidation. Thermal experiments and thermodynamic calculations were used to assess the impact of different Mn–Si ratios on the oxygen content and inclusion characteristics during the deoxidation process of molten steel with different initial oxygen contents. The experimental samples were analyzed using an oxygen–nitrogen–hydrogen analyzer, a direct reading spectrometer, and an automatic scanning electron microscope. After that, the samples were electrolyzed to observe the 2D morphology and 3D morphology of the inclusions using scanning electron microscopy. Finally, thermodynamic calculations were carried out using FactSage to verify the experimental results. The results indicated that, regardless of the initial oxygen content, silicon–manganese deoxidation maintained the total oxygen content at 35 × 10−6. It effectively managed the plasticization of inclusions in molten steel, predominantly yielding spherical silicates while minimizing Al-containing inclusions. Nevertheless, as the initial content of [O] increased, the size and density of the silicate inclusions in the steel also increased. An optimal point in the number and size of inclusions was observed with an increased Mn–Si ratio. Moreover, the combined utilization of silicon–manganese deoxidation, diffusion deoxidation, and vacuum deoxidation enabled ultra-low oxygen content control of molten steel.

A Novel Method of Purifying Metallurgical-Grade Silicon Using Mn As an Impurity Trapping Agent

A High-Efficiency and Energy-Saving Method for Purifying Industrial Silicon for Silicone Use

Enhancing the separation of Fe/Al/Ca impurities from metallurgical silicon to purify by slagging-directional solidification

Removal Mechanism of Mineral Impurities in Molybdenum Concentrate Treatment Process

Enhanced boron removal by CrMnFeNi-based high-entropy alloys during purification of silicon

Removal of Impurities from Metallurgical Grade Silicon During Ga-Si Solvent Refining

Influence of Iron, Aluminum, Calcium, Titanium and Vanadium Impurities Removal from Silicon Based on Cu-catalyzed Chemical Leaching

Removal of impurities from metallurgical grade silicon by addition of ZnO to calcium silicate slag

Comparative study on removal of metallurgical silicon impurities by different acid leaching methods

Impurity removal from Si by Si-Ca-Mg ternary alloying-leaching system

Effects of solidification rate on the leaching behavior of metallic impurities in metallurgical grade silicon

Combining experimental analyses and molecular dynamics simulations in impurity removal at the Si/slag interface

Study of the Preparation of High Purity Silicon by a New Electro-thermal Metallurgy Method

Separation of Al-Si-Fe-(Mn/Cr) melts for simultaneous recycle of Al-Si scraps and purification of silicon

Recovery and Purification of Metallic Silicon from Waste Silicon Slag in Electromagnetic Induction Furnace by Slag Refining Method

Oxide unlocking electron beam melting to separate boron for impurities co-removal of metallurgical grade silicon

Purification of metallurgical-grade silicon combining Sn–Si solvent refining with gas pressure filtration

Effect of Silicon–Manganese Deoxidation on Oxygen Content and Inclusions in Molten Steel

Novel and efficient purification of silicon through ultrasonic-Cu catalyzed chemical leaching

Simultaneous preparation of high-purity silicides, eutectic Si/MSi2 (M: Nb, Ta, Mo, or W) alloys, and silicon through the separation of Si–M solvents using electromagnetic directional crystallization

Recycling of silicon scraps by electron beam melting coupled with directional solidification and its mechanism of impurity removal