Abstract:Pipe cable is considered as an important form for underground transmission line. The maximum electrical current (ampacity) of power cable system mostly depends on the cable conductor temperature. Therefore, accurate calculation of temperature distribution in the power cable system is quite important to extract the cable ampacity. In the present paper, the fluid flow and heat transfer characteristics in the pipe cable with alternating current were numerically studied by using commercial code COMSOL MULTIPHYSICS based on finite element method (FEM). The cable core loss and eddy current loss in the cable were coupled for the heat transfer simulation, and the difference of heat transfer performances with pure natural convection model and radiation-convection model was compared and analysed in detail. Meanwhile, for the radiation-convection model, the effects caused by radiant emissivity of cable surface and pipe inner surface, as well as the cable location in the pipe, were also discussed. Firstly, it is revealed that the radiation and natural convection heat flux on the cable surface would be of the same order of magnitude, and the radiation heat transfer on the cable surface should not be ignored. Otherwise, the cable ampacity would be underestimated. Secondly, it is found that the overall heat transfer rate on the cable surface increases as the cable surface emissivity increases, and this is more remarkable to the upper cable. While the effect caused by the radiant emissivity on the pipe inner surface would be relatively small. Furthermore, it is demonstrated that, as cable location in the pipe falls, the natural convection heat transfer would be enhanced. These results would be meaningful for the ampacity prediction and optimum design for the pipe cable.

Thermal Resistance Properties of the Part between Metal Sheath and Conductor in High-voltage Power Cable

Real‐time Calculation of Three Core Cable Conductor Temperature Based on Thermal Circuit Model with Thermal Resistance Correction

Research on Compensation and Protection of Voltage in Metal Shield of 110kv Power Cable under Three Segments Unsymmetrical State

Investigation on Dielectric Insulation Properties of ±525 Kv HVDC XLPE Material for High Temperatures Applications

Numerical Analysis of Thermo-Electric Field for AC XLPE Cables with Different Service Times in DC Operation Based on Conduction Current Measurement

A Method of Temperature Calculation of Power Cable Conductor

Analysis of the Three-Dimensional Temperature Distribution and Ampacity of Forced Ventilation Multi-loop Cable Tunnel by Finite Element Method

3-D thermal analysis and contact resistance evaluation of power cable joint

Effect of Temperature on Electric-Thermal Properties of Semi-Conductive Shielding Layer and Insulation Layer for High-Voltage Cable

Effect of temperature on electric-thermal properties of semi-conductive shielding layer and insulation layer for high-voltage cable (vol 6, pg 805, 2021)

Numerical analysis of thermo-electric field for 10 kV AC XLPE cable in DC operation

Simulation Analysis of Temperature Field and Electric Field for 10 kV AC XLPE Cable in DC Operation

Numerical Analysis of Thermo-Electric Field for AC XLPE Cable in DC Operation Based on Conduction Current Measurement.

An Improved Analytical Thermal Rating Method for Cable Joints

An improved analytical thermal rating method for cables installed in short-conduits

Temperature Calculation And Measurement On Power Cable Conductor Based On Equivalent Thermal Circuit And Botda

Mathematical Modeling and Current Characteristics Investigation of a 35 Kv Three-in-One High Temperature Superconducting (HTS) Power Cable

Calculation of Loss Factors for Metal Sheath and Armour of HV Cables

Numerical Study of Convection and Radiation Heat Transfer in Pipe Cable

Temperature Field Calculation and Thermal Circuit Equivalent Analysis of 110 kV Core Cable Joint

Analysis on three-core power cable temperature field and ampacity model under typical laying environment