Abstract:The majority of bearingless permanent magnet slice motors (BPMSMs) used in commercially available rotary blood pumps use a two-phase configuration, but it is unclear as to whether or not a comparable three-phase configuration would offer a better performance. This study compares the performance of two-phase and three-phase BPMSM configurations. Initially, two nominal designs were manufactured and empirically tested for their performance characteristics, namely, the axial stiffness, radial stiffness, and current force. Subsequently, finite element analysis (FEA) models were developed based on these nominal devices and validated against the empirical results. Simulations were then employed to assess the sensitivity of performance characteristics to variations in seven different geometric features of the models for both configurations. Our findings indicate that the nominal three-phase design had a higher axial stiffness and radial stiffness, but resulted in a lower axial-to-radial-stiffness ratio when compared to the nominal two-phase design. Additionally, while the nominal two-phase design shows a higher current force, the nominal three-phase design proves to be slightly superior when the force generated is considered relative to the power usage. Notably, the three-phase configuration demonstrates a greater sensitivity to dimensional changes in the geometric features. We observed that alterations in the air gap and rotor length lead to the most significant variations in performance characteristics. Although most changes in specific geometric features entail equal tradeoffs, increasing the head protrusion positively influences the overall performance. Moreover, we illustrated the interdependent nature of the head height and rotor height on the performance characteristics. Overall, this study delineates the strengths and weaknesses of each configuration, while also providing general insights into the relationship between specific geometric features and performance characteristics of BPMSMs.

Basic Characteristics of a 4kw Permanent-Magnet Type Bearingless Slice Motor for Centrifugal Pump System

Active Disturbance Rejection Control for Bearingless Permanent-Magnet Slice Motor Based on Nonlinear Phase-Locked Loop Observer

Principle and simulation of a 5-phase bearingless permanent magnet-type synchronous motor

Principle And Realization Of A 5-Phase Pm Bearingless Motor Drive

Design and Analysis of a 500W 120000rpm High-Speed Permanent Magnet Motor

Research on Bearingless Slice PM Motor

Analysis and Control of Multiphase Permanent-Magnet Bearingless Motor With a Single Set of Half-Coiled Winding

New Proposal of 80-Krpm High-Speed Surface-Mounted Permanent-Magnet Synchronous Motor

Practical Comparison of Two- and Three-Phase Bearingless Permanent Magnet Slice Motors for Blood Pumps

Analysis and Simulation of a 7-Phase PM Bearingless Motor

Analysis and Experiment of a 6-Phase Bearingless Induction Motor

Analysis and Control of Seven-Phase Permanent-Magnet Bearingless Motor with Single Set of Half-Coiled Winding.

Design and implementation of a novel interior permanent magnet bearingless slice motor

Low Vibration and Noise Design of Integrated Permanent Magnet Synchronous Motor (PMSM)

Extracorporeal Blood Pump driven by a Novel Bearingless Split-Tooth Flux-Reversal Motor

Analysis of a New 5-Phase Bearingless Induction Motor

Design and analysis of an axial flux permanent magnet motor for the direct drive radial piston pump

Design of a Medium-Voltage High-Power Brushless Doubly Fed Motor With a Low-Voltage Fractional Convertor for the Circulation Pump Adjustable Speed Drive

High Performance Line Start Permanent Magnet Synchronous Motor for Pumping System

Design and Optimization of BLDC Machine for Bidirectional Impeller Pump

Study on Design and Control of Permanent-Magnet-type Bearingless Motor