Abstract:This paper proposes an architecture of the wireless monitoring system for the real-time monitoring of the orthopedic implants, which monitors the implant duty cycle, detects abnormal asymmetry, high amounts of force, and other conditions of the orthopedic implants. Data for diagnosis are communicated wirelessly by the radio-frequency (RF) signal between the embedded chip and the remote circuit. In different working modes, the system can be powered by the RF signal or stiff lead zirconate-titanate (PZT) ceramics which are able to convert mechanical energy inside the orthopedic implant into electrical energy. The power circuits with a variable ratio switched-capacitor (SC) dc-dc converter have been taped out with 0.35-mum complementary metal-oxide semiconductor (CMOS) technology. The test results show that the SC converter can transfer the input voltage that ranges from 5 V to 14 V from the PZT ceramics into the voltage ranging from 2 V to 2.5 V which will be dealt with by a low drop-out circuit in the future work. The total efficiency of the SC converter is from 28% to 42% at full-time working mode. The analog-to-digital converter (ADC) circuits have been fabricated in a 0.18-mum 1P6M CMOS process. The test results show that the ADC chip consumes only 12.5 muW in working mode and 150 nW in the sleep mode. The circuits, including RF circuits, ADC, and the microcontrol unit, have been implemented in a 0.18-mu m CMOS process. Future work includes some clinical experiments test in the application where PZT elements are used for power generation in total knee-replacement implants.

Low power wireless receiver in CMOS mixed-signal for bio-telemetry implantable system

A receiver analog front-end for body sensor network

Wireless energy and signal transmission system for micro implantable medical system

A 27-Mbps, 0.08-mm3 CMOS Transceiver with Simultaneous Near-field Power Transmission and Data Telemetry for Implantable Systems

A Compact and Low-Power Wireless Receiver for Implanted Medical Backscatter

A High Reliability CMOS Implantable Interface for Wireless Neural Recording Microsystem

An integrated low-power Binary-PAM based wireless telemetry circuit for implantable cardiac pacemakers

Low Power Ic Design of the Wireless Monitoring System of the Orthopedic Implants

A Wireless Artificial Mechanoreceptor in 180-nm CMOS

An Integrated Low-Voltage Ultra-Low-power Reconfigurable Hardware Interface in 0.18-Μm CMOS

CMOS Implementation of a Low-Power BPSK Demodulator for Wireless Implantable Neural Command Transmission

A High-Performance ASK Demodulator for Wireless Recovery System

A 13.56-MHz −25-dBm-Sensitivity Inductive Power Receiver System-on-a-Chip With a Self-Adaptive Successive Approximation Resonance Compensation Front-End for Ultra-Low-Power Medical Implants

Low-power circuits for the bidirectional wireless monitoring system of the orthopedic implants

An Ultra-Low Power 400mhz OOK Transceiver for Medical Implanted Applications.

An area efficient inductorless super-regenerative receiver front-end for biomedical implant devices

Low-Power, High-Data Rate 915 MHz Transceiver with Fully Passive Wake-Up Receiver for Biomedical Implants

Low-power transceiver analog front-end circuits for bidirectional high data rate wireless telemetry in medical endoscopy applications

A 2.4ghz Low Power Wireless Transceiver Analog Front-End for Endoscopy Capsule System

A New Integrated Low-Power BPSK Demodulator for Wireless Implantable Neural Recording System

A Single-Chip Full-Duplex High Speed Transceiver for Multi-Site Stimulating and Recording Neural Implants