Abstract:The main purpose of this paper is to develop an intelligent controller for the DC-link voltage of bidirectional soft-switching converters used in the batteries with equalizing charge and discharge control. To accelerate the equalizing charge and discharge speed of batteries, the DC-link voltage controller of the bidirectional converters is designed based on extension theory. Firstly, the photovoltaic module arrays (PVMAs) are used with the intelligent maximum power point tracker (MPPT) for supplying the power to the load side. Through the bidirectional soft-switching converters, the PVMAs will be allowed to carry out the uniform charging and discharging for the storage battery in order to achieve the intended energy storage and auxiliary power supply functions. In terms of the controller design, the quantitative design techniques are utilized, by which the P-I controller parameters will be designed for the converter when attempting to achieve the same control performance at different working points. As a next step, the aforesaid parameters are used together with the extenics theory. Based on the variation in the output power of the bidirectional converter and that in the voltage of the storage battery, it allows the system to find out the intended P-I controller parameters that will be approximate to the prescribed control performance when operating under different working conditions. As a result, the P-I controller will be provided with more efficient control flexibility and control performances. Finally, actual test results demonstrated that the response time of the proposed intelligent extension controller is shortened by 3% compared to the quantitative design of the proportional–integral (P-I) controller. Based on the proposed quantitative design of an intelligent controller for uniform charging and discharging management of batteries, the sustainable utilization of renewable sources of energy can be improved. At the same time, the better economic benefit of the energy preservation system is obtained. In addition, it also prolongs the life cycle of batteries, and then enhances the reliability of the batteries.

Intelligent Controller for LEDs Lighting Systems Supplied by Batteries

A Digital Controller Based on Primary Side Regulation with Improved Accuracy for LED Application

High-Precision Constant Current Controller For Primary-Side Feedback Led Drivers

A Single-Stage Primary Side Controlled Flyback LED Driver

Research on the Control Method of Constant Current Source Buck Converter for HB-LED

Research on constant current source for LED based on sliding mode control

Photovoltaic intelligent charging controller based on MPPT

An Electrolytic-Capacitorless And Inductorless Ac Direct Led Driver With Power Compensation

A Intelligent Energy Saver for Lighting System with a Novel Converter Circuit Topology

An Intelligent Controller Based on Extension Theory for Batteries Charging and Discharging Control

An Intelligent Controller of LED Street Light Based on Discrete Devices

A Battery to 15~36V Hybrid Boost Converter with 14.4x Max VCR for LED-Lighting

High efficiency quasi-two-stage converter with current balancing for multi-channel LED drive based on AC bus

Intelligent Controller for Photovoltaic Lighting Systems

Optimizing Control for System-Wide State-of-Charge Balancing in Cascaded H-Bridge Battery Energy Storage Systems

Design PV-fed LED streetlight using Soft-Switching bidirectional DC-DC converter with optimal flux control

Power Factor Corrected Primary Side Regulated Flyback Controller For Smart Led Lighting System

An Acht With Eaot Constant Current Control Method In Led Lighting

Research on Battery Charging Control Strategy in Stand-alone Wind/Photovoltaic Hybrid Street Lamp Lighting System

Implementation of solar LED lighting control system based on embedded target modules

An Adaptive Current Control Strategy for Automotive HID Lamps with Full Digital Platform