Abstract:Combined with the development trend of high speed generators and the high voltage of DC microgrids in high-power series hybrid aero propulsion system, a set of hybrid systems with a power of 200 kW, voltage of 540 V, and speed of 21,000 r/min is established in this article. Ground starting tests were conducted, focusing on the analysis of the coupling characteristics between the engine, generator and motors/propellers during the starting process, and further facilitated the optimization of the strategy of starting control. Firstly, the starting process of the series hybrid aero propulsion system mainly consists of four stages: the turboshaft engine is started, the gas turbine speed is increased, the controlled rectification intervenes, and the electric propeller is activated. The recommended definition of the idle state of the 200 kW hybrid propulsion system in this paper is as follows: power turbine speed NP = 10,500 rpm, grid system voltage UDC = 540 V, and the minimum stable power state of the electric motor PM = 150 W. Furthermore, experiments reveal that during the starting process, the resistance value and the rectification strategy, respectively, affect the steady-state and dynamic characteristics of the power turbine speed. By comparing multiple sets of experiments and utilizing data fitting software for optimal design, the results indicate that, based on the starting strategy of no-load protection and two-step controlled rectification, the total duration of the optimized starting process is shortened by 64.7%, and the gas turbine speed is reduced by 22.7% compared to the pre-optimized state. The starting control sequence is clearer, and the optimization effect is significant.

Hybrid electric vehicle quick start capability using Integrated Starter-Generator

Study of a Hybrid Pneumatic-Combustion Engine under Steady-State and Transient Conditions for Transport Application

Active Damping Control of Start-up Process for Hybrid Vehicle

A Moment-of-Inertia-Driven Engine Start-Up Strategy for Four-Wheel-Drive Hybrid Electric Vehicles

Rule-Based Time-Optimal Engine-Start Coordination Control With a Predesigned Vehicle Acceleration Trajectory in P2 Hybrid Electric Vehicles

Hybrid Electric Vehicle Starter/Generator Design Considering Operation States and Control Strategy

Study on the engine start/stop control strategy of hybrid vehicles

Optimal Engine Starts of an Input-Split Hybrid Electric Vehicle

Torque Distribution for an Integrated Starter Generator Parallel Hybrid Electric Car

A Moment-of-Inertia-Driven Engine Start-Up Method Based on Adaptive Model Predictive Control for Hybrid Electric Vehicles With Drivability Optimization

Study of Starting Performance of a Series Hybrid Aero Propulsion System

Fuzzy Logic Based Control for ISG Hybrid Electric Vehicle

The Coordinated Control Strategy of Engine Starting Process in Power Split Hybrid Electric Vehicle Based on Load Observation

Torque Distribution Strategy for Integrated Starter/ Generator Hybrid Bus Implemented by Fuzzy Algorithm

Hybrid Switched Reluctance Integrated Starter And Generator

Parameter matching calibration and implementation of permanent magnet integrated starter/generator system

Analysis and Control of Engine Starting Process Based on a Novel Single-Motor Power-Reflux Hybrid Electric Vehicle

Design of Key Parameters of Diesel ISG Parallel Hybrid Power System

Dynamic Coordinated Control for a Full Hybrid Electric Vehicle with Single Motor

ISG Hybrid Powertrain: a Rule-Based Driver Model Incorporating Look-Ahead Information

Exploring the Fuel Economy Potential of Isg Hybrid Electric Vehicles Through Dynamic Programming