Influence of various implanting angles of micro-implants on peak stress in peri-implant surface

dan lihua,dong fusheng,gong weiwei,zhang xiong

DOI: https://doi.org/10.3321/j.issn:1673-8225.2008.52.005

2008-01-01

Abstract:BACKGROUND:Skeletal anchorage with mini-implants has greatly broadened the treatment possibilities in orthodontics over the last few years.To reduce implant failure rates,it is advisable to obtain adequate stress distribution around implant.OBJECTIVE:To evaluate the stress distribution on bone adjacent to a mini-implant under the different implanting direction and angle.MATERIALS:Jaw data were obtained from the scanning of Dong.Implant model was established according to screwed mini-implant,titanium,Aarhus Screw Syst 1.6,Medicon,Germany.METHODS:Three-dimensional finite element mandible model was established based on the CT scanning data.The mini-implant was implanted in the region between first mola and second premolar at 30°,60° and 90° tilted mesiolly,and 30° and 60° tilted occlusally,respectively.In addition,a force load of 1.96 N was applied horizontally to the head of implant.MAIN OUTCOME MEASURES:The maximum first(pulling) and third(pressing) stress,minimum stress,Von-mises stress and maximum strain were calculated.RESULTS:The peak pulling and pressing stress and Von-mises stress at 30° tilted mesiolly were significantly smaller than the other models.The Von-mises stress mainly located at the neck of implant-bone interface,and decreased rapidly in the lamina cortex.The Von-mises stress in cancellous bone was small,and the side adjacent to loading was pressed,while the other side was pulled.CONCLUSION:Implanting angle shows much more influence on the stress distribution.The stress is primarily located at the neck of implant under different loads.Decreased implanting angle and reduced angle between load line and implant long axis can reduce peak stress.