Investigation of Piezoresistive MEMS Sensors with Different Substrates

隋鸿鹏,张威
DOI: https://doi.org/10.3969/j.issn.1672-6030.2008.03.009
2008-01-01
Nanotechnology and Precision Engineering
Abstract:Three kinds of substrates were used to investigate the performance of piezoresistive MEMS sensors in this experiment.Sheet resistances of piezoresistive area,contact area and protecting area were tested and analysed after the high temperature steps.For piezoresistive areas(P? area),there was no difference between the sheet resistances of A# and B# substrates at the beginning of ions implantation,however, differences became obvious gradually after the impurities diffusing under high temperature condition,because the dopant concentration of substrate had greater effect on impurity distribution after diffusing.By comparing the sheet resistances of piezoresistive areas,the substrate of 20—40 Ω·cm is the best for the design, which has already been used in production.
What problem does this paper attempt to address?