Abstract:A novel plasma-driven catalysis (PDC) reactor with special structure was proposed to remove vehicle exhaust gas. The PDC reactor which consisted of three quartz tubes and two copper electrodes was a coaxial dielectric barrier discharge (DBD) reactor. The inner and outer electrodes firmly surrounded the outer surface of the corresponding dielectric barrier layer in a spiral way, respectively. Nano-titanium dioxide (TiO2) film prepared by radiofrequency (RF) magnetron sputtering was coated on the outer wall of the middle quartz tube, separating the catalyst from the high voltage electrode. The spiral electrodes were designed to avoid overheating of microdischarges inside the PDC reactor. Continuous operation tests indicated that stable performance without deterioration of catalytic activity could last for more than 25 h. To verify the effectiveness of the PDC reactor, a non-thermal plasma(NTP) reactor was employed, which has the same structure as the PDC reactor but without the catalyst. The real vehicle exhaust gas was introduced into the PDC reactor and NTP reactor, respectively. After the treatment, compared with the result from NTP, the concentration of HC in the vehicle exhaust gas treated by PDC reactor reduced far more obviously while that of NO decreased only a little. Moreover, this result was explained through optical emission spectrum. The O emission lines can be observed between 870 nm and 960 nm for wavelength in PDC reactor. Together with previous studies, it could be hypothesized that O derived from catalytically O-3 destruction by catalyst might make a significant contribution to the much higher HC removal efficiency by PDC reactor. A series of complex chemical reactions caused by the multi-components mixture in real vehicle exhaust reduced NO removal efficiency. A controllable system with a real-time feedback module for the PDC reactor was proposed to further improve the ability of removing real vehicle exhaust gas.

Experimental Study on Indoor Air Cleaning Technique of Nano-Titania Catalysis under Plasma Discharge

Experimental Study of Air Cleaning Using a Plasma with TiO2 Catalyst

Air Cleaning by Plasma Combined with Catalyst

Study on Air Cleaning Technology of Nanometer TiO2 Catalysis under Plasma Discharge

Non-thermal Plasma Generation by Using Back Corona Discharge on Catalyst

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Plasma discharge catalyzing nano-TiO 2

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

VOCs degradation with non-thermal plasma and Ag-MnOx catalysis

Aerosol emission and collection in styrene-contaminated air remediation with a multi-stage plasma system

Experimental Analysis on Decomposition of Formaldehyde by Plasma Discharge Catalyzing Nano-TiO2

Indoor air quality improvement and purification by atmospheric pressure Non-Thermal Plasma (NTP)

Utilizing catalyst to enhance pulse discharge for volatile organic compounds treatment

Experimental study on pollutant elimination from indoor air in a new-decorated office

Low temperature plasma-driven catalysis of nanotitanium dioxide for vehicle exhaust clearance

Development and Experimental Investigation of the Narrow-Gap Coated Electrostatic Precipitator with a Shield Pre-Charger for Indoor Air Cleaning

Vehicle Exhaust Gas Clearance By Low Temperature Plasma-Driven Nano-Titanium Dioxide Film Prepared By Radiofrequency Magnetron Sputtering

Purification of Toluene in the Air by Nonthermal Plasma Technique

Ambient Air Purification by Nanotechnologies: From Theory to Application

Process optimization of plasma-catalytic formaldehyde removal using MnOx–Fe2O3 catalysts by response surface methodology

Performance evaluation of a gaseous pollution control device suitable for in situ heating, ventilation and air conditioning applications