Abstract:A general model for hydrogen adsorption is derived to discuss the compressibility of the hydrogen molecules on the adsorption surface caused by the strong adsorptive potential exerted by the carbon wall. The mono-layer capacity (see Table 1) inside the tube of the MWCNTs tested in our laboratory is evalued by the comparison studies on the adsorptive performance between the tubular pore and the slit-pore, the results show that better adsorptive performance can only be obtained when temperature is getting lower or the diameter of the tube is getting smaller(see Fig. 1). From the model, the strong attraction to the surface may even cause hydrogen molecules to attain much higher densities than that of liquid hydrogen, and this will surely make adsorbed hydrogen molecules to behave as repulsion among each other. This phenomenon is discussed in terms of experimental data and the ascertained model (see Fig. 3). A linear form of the model is applied to determine the interaction energy between hydrogen molecules in the adsorbed layer from the experimental data. Analysis of the experimental data of hydrogen adsorption over a wide range of pressure and temperature shows that the energies of hydrogen-hydrogen interactions in the adsorbed phase are positive in low temperature region( < 200 K) and obtain the highest value in the temperature range of 160 similar to 180 K, but will be negative when the temperature is above 230 K(see Fig. 4), indicating the repulsions among the adsorbed hydrogen molecules are prominent in low temperature, however, the attractions among the adsorbed hydrogen molecules at higher temperature are hard to understand because the pressures are also high in those cases. Comments are made that the chemical adsorption should be included to interpret the experimental data at higher temperatures. The results presented here also show that the concept of 'maximum capacity' for hydrogen adsorption should differ from the density of the adsorbed hydrogen molecules.

STUDY ON THE ADSORPTION CHARACTERISTIC OF HYDROGEN ON THE ACTIVATED CARBON AT LOW TEMPERATURES

HYDROGEN ADSORPTION IN ORDERED MESOPOROUS CARBON SYNTHESIZED BY A SOFT-TEMPLATE APPROACH

A Linear Comprehensive Adsorption Model of Hydrogen on Super Activated Carbon under Supercritical Conditions

Temperature dependent behavior of hydrogen molecules on carbon nanostructures

Theoretical Study on the Adsorbed Hydrogen Molecules on Multi-Walled Carbon Nanotubes

Effects of Thermal Activation Conditions on the Microstructure Regulation of Corncob-Derived Activated Carbon for Hydrogen Storage

Pore Size Effects of Nanoporous Carbons with Ultra-High Surface Area on High-Pressure Hydrogen Storage

Adsorption of Hydrogen in Microporous Carbon Adsorbents of Different Origin

DETERMINATION OF ISOSTERIC HEAT OF ADSORPTION OF HYDROGEN ON CARBON-BASED ADSORBENTS WITH NONLOCAL DENSITY FUNCTIONAL THEORY APPROACH

The Determination Of The Isosteric Heat Of Hydrogen Adsorption On Carbon Adsorbents From The Nonlocal Density Functioanal Theory Approach

Adsorption of hydrogen on porous materials of activated carbon and zeolite NaX crossover critical temperature

New Perspectives on the Effects of Texture and Chemical Properties on the Hydrogen Storage Capacity of Biochar at Room Temperature

Microstructure regulation of super activated carbon from biomass source corncob with enhanced hydrogen uptake

Temperature-dependent State of Hydrogen Molecules Within the Nanopore of Multi-Walled Carbon Nanotubes

Numerical simulation and optimization analysis of low temperature adsorption hydrogen storage

Hydrogen Adsorption, Migration and Desorption on Amorphous Carbon: A DFT and AIMD Study

High-pressure hydrogen storage and optimizing fabrication of corncob-derived activated carbon

A REVIEW OF ACTIVATED CARBON MATERIALS FOR HYDROGEN STORAGE

Adsorption of ammonia on activated carbon from aqueous solutions

The Preparation of Super-Activated Carbons and Its Properties for Hydrogen Storage

Experimental Study and Computer Simulation of Hydrogen Adsorption on Carbon Nanofibres.