Abstract:A general model for hydrogen adsorption is derived to discuss the compressibility of the hydrogen molecules on the adsorption surface caused by the strong adsorptive potential exerted by the carbon wall. The mono-layer capacity (see Table 1) inside the tube of the MWCNTs tested in our laboratory is evalued by the comparison studies on the adsorptive performance between the tubular pore and the slit-pore, the results show that better adsorptive performance can only be obtained when temperature is getting lower or the diameter of the tube is getting smaller(see Fig. 1). From the model, the strong attraction to the surface may even cause hydrogen molecules to attain much higher densities than that of liquid hydrogen, and this will surely make adsorbed hydrogen molecules to behave as repulsion among each other. This phenomenon is discussed in terms of experimental data and the ascertained model (see Fig. 3). A linear form of the model is applied to determine the interaction energy between hydrogen molecules in the adsorbed layer from the experimental data. Analysis of the experimental data of hydrogen adsorption over a wide range of pressure and temperature shows that the energies of hydrogen-hydrogen interactions in the adsorbed phase are positive in low temperature region( < 200 K) and obtain the highest value in the temperature range of 160 similar to 180 K, but will be negative when the temperature is above 230 K(see Fig. 4), indicating the repulsions among the adsorbed hydrogen molecules are prominent in low temperature, however, the attractions among the adsorbed hydrogen molecules at higher temperature are hard to understand because the pressures are also high in those cases. Comments are made that the chemical adsorption should be included to interpret the experimental data at higher temperatures. The results presented here also show that the concept of 'maximum capacity' for hydrogen adsorption should differ from the density of the adsorbed hydrogen molecules.

DETERMINATION OF ISOSTERIC HEAT OF ADSORPTION OF HYDROGEN ON CARBON-BASED ADSORBENTS WITH NONLOCAL DENSITY FUNCTIONAL THEORY APPROACH

The Determination Of The Isosteric Heat Of Hydrogen Adsorption On Carbon Adsorbents From The Nonlocal Density Functioanal Theory Approach

HYDROGEN ADSORPTION IN ORDERED MESOPOROUS CARBON SYNTHESIZED BY A SOFT-TEMPLATE APPROACH

Experimental Study and Computer Simulation of Hydrogen Adsorption on Carbon Nanofibres.

Density Functional Study of the Adsorption and Separation of Hydrogen in Single-Walled Carbon Nanotube

Theoretical Study on the Adsorbed Hydrogen Molecules on Multi-Walled Carbon Nanotubes

STUDY ON THE ADSORPTION CHARACTERISTIC OF HYDROGEN ON THE ACTIVATED CARBON AT LOW TEMPERATURES

Temperature dependent behavior of hydrogen molecules on carbon nanostructures

Temperature-dependent State of Hydrogen Molecules Within the Nanopore of Multi-Walled Carbon Nanotubes

Density Functional Study of Hydrogen Adsorption at Low Temperatures

The Grand Canonical Monte Carlo Simulation of Hydrogen Physisorption on Single-Walled Carbon Nanotubes at the Low and Normal Temperatures

Density Functional Theory Study on Hydrogen Adsorption on Be(0001) Surface

HYDROGEN ADSORPTION STORAGE STUDY ON MULTI-WALLED CARBON NANOTUBES

Binding Energies and Electronic Properties of Hydrogen Adsorptions on 4-Angstrom Carbon Nanotubes

Study of H2 Physical Adsorption in Single-Walled Carbon Nanotube Array

Grand Canonical Monte Carlo Simulation of Hydrogen Adsorption in Different Carbon Nano Structures

The Prediction of the Adsorption of Hydrogen within the Slit-pores of Carbon Micro-pore Adsorbents

Electronic Supplementary Information Adsorption Behaviour of CH 4 on Microporous Carbons : Effect of Surface Heterogeneity

Supercritical Hydrogen Adsorption in Nanostructured Solids with Hydrogen Density Variation in Pores

The performance analysis of hydrogen adsorption storage in carbon nanofibres

Comparative Study of Hydrogen Adsorption on Carbon and BN Nanotubes.