Abstract:A general model for hydrogen adsorption is derived to discuss the compressibility of the hydrogen molecules on the adsorption surface caused by the strong adsorptive potential exerted by the carbon wall. The mono-layer capacity (see Table 1) inside the tube of the MWCNTs tested in our laboratory is evalued by the comparison studies on the adsorptive performance between the tubular pore and the slit-pore, the results show that better adsorptive performance can only be obtained when temperature is getting lower or the diameter of the tube is getting smaller(see Fig. 1). From the model, the strong attraction to the surface may even cause hydrogen molecules to attain much higher densities than that of liquid hydrogen, and this will surely make adsorbed hydrogen molecules to behave as repulsion among each other. This phenomenon is discussed in terms of experimental data and the ascertained model (see Fig. 3). A linear form of the model is applied to determine the interaction energy between hydrogen molecules in the adsorbed layer from the experimental data. Analysis of the experimental data of hydrogen adsorption over a wide range of pressure and temperature shows that the energies of hydrogen-hydrogen interactions in the adsorbed phase are positive in low temperature region( < 200 K) and obtain the highest value in the temperature range of 160 similar to 180 K, but will be negative when the temperature is above 230 K(see Fig. 4), indicating the repulsions among the adsorbed hydrogen molecules are prominent in low temperature, however, the attractions among the adsorbed hydrogen molecules at higher temperature are hard to understand because the pressures are also high in those cases. Comments are made that the chemical adsorption should be included to interpret the experimental data at higher temperatures. The results presented here also show that the concept of 'maximum capacity' for hydrogen adsorption should differ from the density of the adsorbed hydrogen molecules.

Density Functional Study of Hydrogen Adsorption at Low Temperatures

Density Functional Study of the Adsorption and Separation of Hydrogen in Single-Walled Carbon Nanotube

Equilibrium, Kinetics and Enthalpy of Hydrogen Adsorption in MOF-177

Path Integral Simulation of Hydrogen Adsorption in Single-Walled Carbon Nanotubes at Low Temperatures

Monte Carlo Simulations Of Hydrogen Adsorption In Single-Walled Carbon Nanotubes

The Determination Of The Isosteric Heat Of Hydrogen Adsorption On Carbon Adsorbents From The Nonlocal Density Functioanal Theory Approach

Temperature dependent behavior of hydrogen molecules on carbon nanostructures

Theoretical Study on the Adsorbed Hydrogen Molecules on Multi-Walled Carbon Nanotubes

Grand Canonical Monte Carlo Simulation of Hydrogen Adsorption in Different Carbon Nano Structures

Modeling of low temperature adsorption of hydrogen in carbon nanopores

The Grand Canonical Monte Carlo Simulation of Hydrogen Physisorption on Single-Walled Carbon Nanotubes at the Low and Normal Temperatures

Importance of van der Waals interactions in hydrogen adsorption on a silicon-carbide nanotube revisited with vdW-DFT and quantum Monte Carlo

Density Functional Theory Study on Hydrogen Adsorption on Be(0001) Surface

Binding Energies and Electronic Properties of Hydrogen Adsorptions on 4-Angstrom Carbon Nanotubes

Theoretical study of hydrogen adsorption in single-walled carbon nanotubes by first principles molecular dynamics method

Simulation Study of Hydrogen Storage in Single Walled Carbon Nanotubes

Hydrogen chemisorption on Co(0001) surface: A DFT study

Experimental Study and Computer Simulation of Hydrogen Adsorption on Carbon Nanofibres.

Temperature-dependent State of Hydrogen Molecules Within the Nanopore of Multi-Walled Carbon Nanotubes

DETERMINATION OF ISOSTERIC HEAT OF ADSORPTION OF HYDROGEN ON CARBON-BASED ADSORBENTS WITH NONLOCAL DENSITY FUNCTIONAL THEORY APPROACH

Theoretical Studies on Hydrogen Adsorption of Single-Walled Boron-Nitride and Carbon Nanotubes Using Grand Canonical Monte Carlo Method