Abstract:Quenching experiments were performed with hot stainless steel spheres in a pool of water-based nanofluids in the presence of carbon nanotubes (CNTs) of various sizes. In order to explore the size effect, a test matrix was developed by choosing multi-walled CNTs with lengths from 1 μm to 5 μm and outer diameters from 30 nm to 60 nm. The concentration was fixed at 0.5% by mass for all types of CNTs. The initial temperature was 400 °C and the transient temperature variations at the center of the sphere were recorded as quenching curves. By establishing a lumped capacitance model, the transient surface heat flux variations were obtained as boiling curves. The original and boiled surfaces were both subjected to a series of characterizations to determine the changes in morphology, roughness, and wettability to identify the effects of CNT size on the surface properties of the formed deposition layers as well as to elucidate the mechanisms for regulation of the boiling and quenching behaviors. The results suggested that the critical heat flux (CHF) and the Leidenfrost point (LFP) are enhanced to various degrees due to the discrepancy in the size of the CNTs in nanofluids. It was shown that the CNTs deposited on the surfaces create various morphologies depending on their size. The CNTs with a length of 5 μm and a diameter of 60 nm exhibited the most significant effect on the boiling behaviors. In comparison to CNTs with a shorter length of 1 μm, the 5 μm long CNTs were much easier to form porous layers. The results of the contact angle and roughness tests showed that the porous layers tend to affect the surface roughness instead of surface wettability. The increases of the nucleation site density and surface roughness due to the presence of porous layers were identified as the primary cause for the modified boiling behaviors during quenching.

Experiment of Carbon Nanotube Suspension on the Thermal Performance of a Miniature Flat Heat Pipe Evaporator with Micro-Grooved Surface

Characteristics of Carbon Nanotube Nanofluid and Heat Transfer in Gravity Heat Pipe

Experimental study on the thermal conductivity enhancement of water based nanofluids using different types of carbon nanotubes

Thermal Performance of an Axially Microgrooved Heat Pipe Using Carbon Nanotube Suspensions

Thermo-physical properties of water-based single-walled carbon nanotube nanofluid as advanced coolant

Experimental Investigation and Modelling on the Thermal Conductivity of CNTs Based Nanofluids

An Experimental Study of Boiling Heat Transfer During Quenching of Nanofluids with Carbon Nanotubes of Various Sizes

Boiling characteristics of carbon nanotube suspensions under sub-atmospheric pressures

The Interface Effect Of Carbon Nanotube Suspension On The Thermal Performance Of A Two-Phase Closed Thermosyphon

Experimental Study on Forced Convective Heat Transfer of CNT Nanofluids in Microtube

Pool Boiling Heat Transfer During Quenching in Carbon Nanotube (Cnt)-Based Aqueous Nanofluids: Effects of Length and Diameter of the CNTs

Heat Transfer and Pressure Drop of Nanofluids Containing Carbon Nanotubes in Laminar Flows

Investigation of Flow Boiling Heat Transfer Characteristics of CO2in Horizontal Mini-Tube

Boiling characteristics of carbon nanotube suspension in gravity-assisted thermosyphon

Numerical Modeling of Turbulent Heat Transfer of a Nanofluid at Supercritical Pressure

Quenching boiling of aqueous suspensions with carbon nanotubes

Study of flow boiling heat transfer characteristics of critical heat flux using carbon nanotubes and water nanofluid

Molecular study on convective heat transfer of nanofluid in nanochannel: effect of CNT particles

Experimental Investigation on Heat Transfer of Carbon Nanotube Membranes

Effect of C60 Nanofluid on the Thermal Performance of a Flat-Plate Pulsating Heat Pipe

Experimental Investigation of Thermal Conduction Performance on Silicon-Based Micro Flat Heat Pipe