Abstract:This work reports a new simulated inductor which is suitable for a Contactless Electrical Tomography (CET) system and can effectively overcome the unfavorable influence of coupling capacitance on the measurement results. By detailed analysis and comparison, it is found that the grounded simulated inductor has a simple circuit construction but its output current is not equal to its input current, while the floating simulated inductor can be used as an independent inductor module but its circuit structure is relatively complex. A new simulated inductor is designed by compensating the currents from the common node of an introduced independent power source to the main circuit. The new simulated inductor combines the advantages of the grounded simulated inductor and the floating simulated inductor. It has the simple construction similar to that of the grounded simulated inductor and its input current is equal to the output current, which means it can be used as an independent module. The impedance measurement and practical image reconstruction experiments were carried out to verify the effectiveness of the new simulated inductor. The experimental results show that the design of the new simulated inductor is successful, and the performance of the impedance measurement is satisfactory. The signal-to-noise ratio of the CET system is improved. Meanwhile, the research work also indicates that in the case when the independent power source is not available, the new simulated inductor is also an effective alternative method. But the phase difference between input signal and output signal is approximately 90° when the elimination principle is realized.

Transient characteristics of Rogowski coil-based current sensor

A Differential Compensated Air Coil Current Sensor for Switching Current Measurement of Power Devices.

On the Design of a New Simulated Inductor Using a Contactless Electrical Tomography System As an Example

Development of the Test Platform for the Characteristics of the Rogowski Coil Electronic Current Transformer

New C4D Sensor with a Simulated Inductor

Study on the Application of Simulated Inductor Technique to the Design of C 4 D Sensor

Temperature Characteristics of Rogowski Coil Current Sensors

Self-integral Rogowski Coil for Measurement of 10/350 Μs Impulse Current Waveform

Measurement of Transient Current in High-Voltage and Power System Using Rogowski Coil

A Self-Integrating Rogowski Coil for Lightning Current Sensor

Sensor Head of Electronic Current Transformer Based on Rogowski Coil

Large bandwidth and dynamic range current sensor based on micro-PCB Rogowski coil

Research on A Novel Current Transducer Based on Discrete Rogowski Coils

Thunder Current Measurement Using Rogowski Coil

Influence of Buffer Resistance and Element with Imperfect Characteristic on External Integrating Rogowisk Coil

Modeling and Transfer Characteristics Simulation Analysis of Electronic Current Transformers

Development on Rogowski coil measuring nanoseconds risetime megampere currents

Development on Rogowski Coil for Measuring 10/350 Μs Direct Lightning Current

A Novel Test Approach for Additional Dynamic Component of Electronic Current Transducer Based on Rogowski Coil.

Transient Performance Simulation for Current Transformers

VIRTUAL INSTRUMENT TECHNOLOGY IN ELECTRONIC CURRENT TRANSFORMER