Abstract:A recently proposed baseline shaped film cooling hole is numerically investigated on a flat plate at four blowing ratios (M), 0.5, 1.0, 2.0 and 3.0 and two density ratios (DR), 1.2 and 1.5. Results show that there exists an optimal blowing ratio and a best coolant operating condition in the current simulation set. The cooling effectiveness shows insensitivity to changes in density ratio for the same blowing ratio no higher than 1.0. A high density ratio effectively compensates for the negative impacts brought by a higher blowing ratio coolant than the optimal. It is also summarised that a velocity ratio (VR) around 1 should be a division point where the coolant flow behaviour differentiates and thus decides the cooling performance characteristics. Specifically, this paper proposes the idea of the quantification of two-dimensional film cooling performance, through three additional parameters: area-averaged adiabatic cooling effectiveness, standard deviation of adiabatic cooling effectiveness distribution and a defined distortion factor measuring the uniformity of adiabatic cooling effectiveness distribution. Different conclusions concerning the optimal coolant operating condition are drawn based on whether these two-dimensional cooling performance parameters or the commonly employed one-dimensional parameters, centreline and lateral-averaged adiabatic cooling effectiveness, are applied for evaluation. When using one-dimensional parameters, the DR = 1.5 M = 2.0 case is the best coolant operating condition, while using the two-dimensional parameters, the optimal condition changes to DR = 1.5 M = 1.0 and the optimal blowing ratio also changes from 2.0 to 1.0. Besides, the DR = 1.2 M = 3.0 case becomes the worst cooling performance working condition instead of the two M = 0.5 cases. In addition, VR is found to better scale and predict area-averaged cooling effectiveness. Some new information on the uniformity and the variation level of cooling effectiveness distribution under various coolant operating conditions is also revealed. Visualisation of the flow field structures shows that the two-dimensional cooling performance is decided by the offsetting results of the negative and positive influences from the counter-rotating vortex development in lateral, spanwise and streamwise directions.

Numerical study of the effect of internal coolant crossflow on film cooling effectiveness

Experimental and numerical study of film cooling with internal coolant cross-flow effects

Large-Eddy Simulation of Film Cooling with Internal Coolant Crossflow Effects

Effect of internal cross flow on double jet film cooling holes of helium turbine blades

Experimental and Numerical Investigations of Shaped Hole Film Cooling with the Influence of Endwall Cross Flow

Film Cooling Measurements for a Laidback Fan-Shaped Hole: Effect of Coolant Crossflow on Cooling Effectiveness and Heat Transfer

Numerical Investigation on a Baseline Shaped Film Cooling Hole: One- and Two-Dimensional Cooling Performance

Effects of film hole spanwise angle and diameter on flow and heat transfer of impingement/effusion cooling with crossflow diverters

Experimental investigation and numerical analysis on effects of swirling coolant on flow characteristics and film cooling performance

Experimental and Numerical Investigation on Film Cooling Performance and Flow Structure of Film Holes

Effect of different internal impingement structures and cratered film cooling holes on overall cooling effectiveness

Film Cooling Effectiveness with Different Hole Shapes with a Constant Flow Area

Influence of hole geometry on film cooling effectiveness for a constant exit flow area

INFLUENCE OF MAINSTREAM CROSS FLOW ON FILM COOLING PERFORMANCE AND JET FLOW FIELD

Numerical Investigation of Film Cooling Effectiveness on a Rotating Turbine Blade Model

Large eddy simulation of internal coolant crossflow orientation effects on film-cooling effectiveness of fan-shaped holes

Experimental and numerical investigation on the film cooling performance of cylindrical hole and fan-shaped hole with vortex generator fed by crossflow

Effect of Ribbed and Smooth Coolant Cross-Flow Channel on Film Cooling

Numerical Investigation of Effects of Blockage, Inclination Angle, and Hole-Size on Film Cooling Effectiveness at Concave Surface

Film Superposition Characteristics With Laidback Fan-Shaped Holes Under the Influence of Internal Crossflow

Trajectory and Effectiveness of Film Cooling in Endwall Crossflow