Abstract:A recently proposed baseline shaped film cooling hole is numerically investigated on a flat plate at four blowing ratios (M), 0.5, 1.0, 2.0 and 3.0 and two density ratios (DR), 1.2 and 1.5. Results show that there exists an optimal blowing ratio and a best coolant operating condition in the current simulation set. The cooling effectiveness shows insensitivity to changes in density ratio for the same blowing ratio no higher than 1.0. A high density ratio effectively compensates for the negative impacts brought by a higher blowing ratio coolant than the optimal. It is also summarised that a velocity ratio (VR) around 1 should be a division point where the coolant flow behaviour differentiates and thus decides the cooling performance characteristics. Specifically, this paper proposes the idea of the quantification of two-dimensional film cooling performance, through three additional parameters: area-averaged adiabatic cooling effectiveness, standard deviation of adiabatic cooling effectiveness distribution and a defined distortion factor measuring the uniformity of adiabatic cooling effectiveness distribution. Different conclusions concerning the optimal coolant operating condition are drawn based on whether these two-dimensional cooling performance parameters or the commonly employed one-dimensional parameters, centreline and lateral-averaged adiabatic cooling effectiveness, are applied for evaluation. When using one-dimensional parameters, the DR = 1.5 M = 2.0 case is the best coolant operating condition, while using the two-dimensional parameters, the optimal condition changes to DR = 1.5 M = 1.0 and the optimal blowing ratio also changes from 2.0 to 1.0. Besides, the DR = 1.2 M = 3.0 case becomes the worst cooling performance working condition instead of the two M = 0.5 cases. In addition, VR is found to better scale and predict area-averaged cooling effectiveness. Some new information on the uniformity and the variation level of cooling effectiveness distribution under various coolant operating conditions is also revealed. Visualisation of the flow field structures shows that the two-dimensional cooling performance is decided by the offsetting results of the negative and positive influences from the counter-rotating vortex development in lateral, spanwise and streamwise directions.

Effect of different internal impingement structures and cratered film cooling holes on overall cooling effectiveness

Conjugate Heat Transfer Simulation of Overall Cooling Performance for Cratered Film Cooling Holes

Experimental Heat Transfer and Cooling Effectiveness over an Effusion Wall with Internal Jet-Array Impingement: Influence of Hole Arrangement

Optimal Arrangement of Combined-Hole for Improving Film Cooling Effectiveness

Film Cooling Effectiveness with Different Hole Shapes with a Constant Flow Area

Influence of Jet Impingement Configurations and Aerothermal Variables on Film Cooling

Numerical Investigation on a Baseline Shaped Film Cooling Hole: One- and Two-Dimensional Cooling Performance

Influence of hole geometry on film cooling effectiveness for a constant exit flow area

Effects of mainstream cross-flow and wall contouring on film cooling effectiveness of cylindrical-holes embedded in elliptical craters

Numerical Investigation of Effects of Blockage, Inclination Angle, and Hole-Size on Film Cooling Effectiveness at Concave Surface

Numerical Evaluation of Novel Shaped Holes for Enhancing Film Cooling Performance

Experimental and Numerical Investigation on Film Cooling Performance and Flow Structure of Film Holes

THE EFFECT OF IMPINGEMENT-EFFUSION COOLING STRUCTURE ON ADIABATIC FILM EFFECTIVENESS

Effects of film hole spanwise angle and diameter on flow and heat transfer of impingement/effusion cooling with crossflow diverters

Study of the effect of particle deposition characteristics and hole blockage of film holes on the cooling efficiency

Film Cooling Effectiveness and Flow Structures of Butterfly-Shaped Film Cooling Hole Configuration

Experimental and numerical study of film cooling with internal coolant cross-flow effects

Experimental investigation and numerical analysis on effects of swirling coolant on flow characteristics and film cooling performance

Effect of Film Cooling Arrangement on Impingement Heat Transfer on Turbine Blade Leading Edge

Heat Transfer Characteristics of Fan-Shaped Hole Effusion Cooling for a Constant Hole Exit Width – Numerical Simulation and Experimental Validation

Investigations of effect for different influencing factors on film cooling effectiveness—Steady coolant ejected