Abstract:The prospect of blending gasoline fuel with ethanol is being investigated as a potential way to improve the knock residence of the base gasoline. However, one of the drawbacks is a lack of proper understanding of the reason for the non-linear response of blending ethanol and gasoline. This non-linearity could be better understood by an improved knowledge of the interactions of these fuel components at a molecular level. This study proposed a highly reduced four-component (toluene/n-heptane/iso-octane/ethanol) gasoline surrogate model containing 59 species and 270 reactions. The model was reduced using the direct relation graph with expert knowledge (DRG-X) (Lu and Law, 20015; Lu et al., 2011) and isomer lumping method. The computational singular perturbation (CSP) analysis were performed to reduce the potential stiffness issues by accordingly adjusting the Arrhenius coefficients of the proper reactions. The model has been comprehensively validated against wide range of ignition delay times (IDT) and flame speed (FS) measurement data as well as compared against two representative literature models from Liu et al. (2013) and Wang et al. (2015). Overall, good agreements were observed between model predictions and experimental data across the entire research octane number (RON), equivalence ratio, pressure and temperature range. In addition, the model has also been coupled with the computational fluid dynamic (CFD) models to simulate the experimental data of constant volume reacting spray of a low-octane gasoline (Haltermann straight-run naphtha), and in-cylinder pressures and temperatures of a high-octane gasoline (Haltermann Gasoline) combustion in a heavy duty compression ignition engine. The coupled model can qualitatively predict the experimentally obtained data with an improved performance for PRF, TPRF, and TPRF-ethanol surrogates.

Simulation Study of FCC Light Gasoline Etherification Using a Combined Method

Simulation, sensitivity analysis and optimization of a continuous catalytic reforming process

Modeling, Simulation and Optimization of a Whole Industrial Catalytic Naphtha Reforming Process on Aspen Plus Platform

Molecule Simulation for the Secondary Reactions of Fluid Catalytic Cracking Gasoline by the Method of Structure Oriented Lumping Combined with Monte Carlo

Study on the Adaptability of Etherification Feedstock to Reactor Type

Development of a Reduced Four-Component (Toluene/n-Heptane/iso-octane/ethanol) Gasoline Surrogate Model

Combined dealkylation and transalkylation reaction in FCC condition for efficient conversion of light fraction light cycle oil into value-added products

Study on the FCC process of a novel riser-downer coupling reactor (III): Industrial trial and-CFD modeling

Molecular level analysis on performance of diameter expanding reactor to improve gasoline quality in FCC process

Simulation and optimization of aromatic extraction from lube oil cuts by liquid-liquid extraction

Molecular Level Simulation of the Conversion and Distribution of Sulfides in the Fluid Catalytic Cracking and Hydrotreating Processes to Improve the Cleanliness of Gasoline and Diesel

Analysis of FCC Light Gasoline and It′s Etherified Products

STUDY ON COMBINATION PROCESS OF INFERIOR GAS OIL HYDROTREATING AND FCC

Simulation and Optimization of Fusel Oil Separation in Ethanol Distillation Process

An Orthogonal Method for Aromatization Reactions of Shenghua Fcc Gasoline

Modeling and Optimization of a Fractionation, Absorption, and Stabilization System in an Industrial Fluid Catalytic Cracking Process

Process simulation based on experimental investigations for 3-methylthiophene alkylation with isobutylene in a reactive distillation column

Feedstock Molecular Reconstruction for Secondary Reactions of Fluid Catalytic Cracking Gasoline by Maximum Information Entropy Method

Fischer-Tropsch wax catalytic cracking for the production of low olefin and high octane number gasoline: Experiment and molecular level kinetic modeling study

Molecular Modeling and Optimization for Catalytic Reforming

Process Simulation and Optimization of Fluid Catalytic Cracking Unit's Rich Gas Compression System and Absorption Stabilization System