Abstract:Desiccant wheels have been widely used in humidity control, particularly under conditions with ultra-low dew point temperatures. However, traditional desiccants such as silica gel and zeolites are subject to relatively low adsorption capacity and high regeneration temperature. To address these challenges, a type of polymer material with high water uptake and low regeneration temperature is investigated in this paper. Firstly, the adsorption/desorption capacity of this polymer is thoroughly tested. Results reveal that its remarkable equilibrium adsorption capacity and desorption rate coefficients k LDF,de are 350% and 32%-64% higher than that of silica gel, respectively. Moreover, its required regeneration temperature is just about 40°C-70°C. The performance of the desiccant wheel using this polymer is simulated by a model validated by experiments tests. Parameter analysis demonstrates that the desiccant wheel is suitable for cool and humid conditions, reaching the maximum moisture removal (∆ Y ) and dehumidification coefficient of performance (DCOP) of 4.0g kg −1 and 0.66, respectively. Furthermore, the corresponding relationship between other parameters and the optimal rotation speed is discussed in detail. The ω opt is around 18rph, enabling the attainment of the highest ∆ Y . Finally, the performance comparison with a traditional silica gel desiccant wheel is carried out. The results indicate that the polymer one performs 17%-53.9% higher in terms of both ∆ Y and DCOP than the silica gel counterpart. And the most significant improvement is observed in low relative humidity conditions (45%RH), where ∆ Y and DCOP are 1.25-1.53 times that of the silica gel's, highlighting the advantageous utilization of the polymer material.

Numerical simulation of characteristics of enthalpy recovery wheel with different desiccants

Performance comparison between enthalpy recovery wheels and dehumidification wheels

A mathematical model for predicting the performance of a compound desiccant wheel (A model of compound desiccant wheel)

Experiment and analysis of desiccant coating processes for enthalpy wheel heat exchangers

Experimental Study on Desiccant-Wheel Dehumidification Performance

Experimental Investigation on Dynamic Dehumidification Performance of Rotary Desiccant Weels

Experimental and Numerical Analysis on Heat and Moisture Recovery Performance of Enthalpy Wheel with Condensation

Performance Optimization of Silica Gel-Lithium Chloride Composite Desiccant Dehumidification Wheel

A Simulation Study of Heat and Mass Transfer in A Honeycombed Rotary Desiccant Dehumidifier

Analysis of Optimized Wheel Rotation Speed of Composite Desiccant Based on Silica Gel

Use of compound desiccant to develop high performance desiccant cooling system

Parametric Studies of Silica Gel and Molecular Sieve Desiccant Wheels: Experimental and Modeling Approaches

Performance Comparison of Enthalpy Recovery Devices Using Liquid Desiccant and Desiccant Wheel

Experimental Studies On Performance Of Three Rotary Dehumidifiers Fabricated With Corrugated Honey-Comb Paper Coated With Different Desiccant Materials

Parametric Study on the Silica Gel-Calcium Chloride Composite Desiccant Rotary Wheel Employing Fractal Bet Adsorption Isotherm

Experimental testing on contaminant and moisture removal performance of silica gel desiccant wheel

Experimental investigations on desiccant wheels

Experimental Comparison of Two Honeycombed Desiccant Wheels Fabricated with Silica Gel and Composite Desiccant Material

A Review of the Mathematical Models for Predicting Rotary Desiccant Wheel

Performance analysis of a rotary desiccant wheel using polymer material with high water uptake and low regeneration temperature

Analysis of Heat and Mass Exchange Performance of Enthalpy Recovery Wheel