Abstract:Despite numerous studies undertaken to define the development and significance of the dynamic membrane (DM) formed on some coarse materials, the optimization of reactor configuration and the control of the membrane fouling of anaerobic dynamic membrane bioreactor (AnDMBR) need to be further investigated. The aim of this study was to design a novel anaerobic gravity-driven dynamic membrane bioreactor (AnGDMBR) for the effective and low-cost treatment of municipal wastewater. An 800 mesh nylon net was determined as the optimal support material based on its less irreversible fouling and higher effluent quality by the dead-end filtration experiments. During the continuous operation period of 44 days, the reactor performance, DM filtration behavior and microbial characteristics were studied and compared with the results of recent studies. AnGDMBR had a higher removal rate of chemical oxygen demand (COD) of 85.45 ± 7.06%. Photometric analysis integrating with three-dimensional excitation–emission matrix fluorescence spectra showed that the DM effectively intercepted organics (46.34 ± 16.50%, 75.24 ± 17.35%, and 66.39 ± 17.66% for COD, polysaccharides, and proteins). The addition of suspended carriers effectively removed the DM layer by mechanical scouring, and the growth rate of transmembrane pressure (TMP) and the decreasing rate of flux were reduced from 18.7 to 4.7 Pa/h and 0.07 to 0.01 L/(m2·h2), respectively. However, a dense and thin morphological structure of the DM layer was still observed in the end of reactor operation and plenty of filamentous microorganisms (i.e., SJA-15 and Anaerolineaceae) and the acidogens (i.e, Aeromonadaceae) predominated in the DM layer, which was also embedded in the membrane pore and led to severe irreversible fouling. In summary, the novel AnGDMBR has a superior performance (higher organic removal and lower fouling rates), which provides useful information on the configuration and operation of AnDMBRs for municipal wastewater treatment.

Theoretical Analysis and Experimentation about Configuration Optimization of Self-Forming Dynamic Membrane Bio-Reactor

Characteristics of a Self-Forming Dynamic Membrane Coupled with a Bioreactor for Municipal Wastewater Treatment.

Recovery of Organic Matters in Wastewater by Self-Forming Dynamic Membrane Bioreactor: Performance and Membrane Fouling.

Function of dynamic membrane in self-forming dynamic membrane coupled bioreactor.

Superior performance of a membrane bioreactor through innovative in-situ aeration and structural optimization using computational fluid dynamics

Function of Self-Forming Dynamic Membrane and Biokinetic Parameters' Determination by Microelectrode

Computational Fluid Dynamics Simulation As A Tool For Optimizing The Hydrodynamic Performance Of Membrane Bioreactors

Flow Manifold Optimization for a Uniform Velocity Distribution in a Laminated Microreactor with Micro‐Pin‐Fin Arrays

Optimization of Membrane Unit Location in a Full-Scale Membrane Bioreactor Using Computational Fluid Dynamics

Operation Characteristics of Self-forming Dynamic Membrane Bioreactor for Municipal Sewage Treatment

Operational Stability of Dynamic Membrane Bioreactor and Its Influence Factors

Numerical simulation of scaling-up for AEC-MBRs regarding membrane module configurations and cyclic aeration modes

Innovation and optimization of aeration in free bubbling flat sheet MBRs

Analysis of the Mixing Performance of a Full-Scale Membrane Bioreactor for Municipal Wastewater Treatment

A Novel Anaerobic Gravity-Driven Dynamic Membrane Bioreactor (AnGDMBR): Performance and Fouling Characterization

Hydrodynamic optimization of membrane bioreactor by horizontal geometry modification using computational fluid dynamics.

Design and Analysis of A Submerged Membrane Reactor by Cfd Simulation

Aeration pipe design for free bubbling hydrodynamic optimization of flat sheet MBRs

Operating Characteristics of Self-forming Dynamic Membrane Bioreactor at High Flux

Study of a membrane bioreactor with glass fiber flat grille modules and the modules' optimization based on the local critical flux theory

Membrane Module Design of Multieffect Plate Membrane Distillation and Computational Fluid Dynamics Simulation