Abstract:Compared with wavelet analysis method of signal data, HHT (Hilbert-Huang Transform) method is widely used for the local signal data analysis in the time–frequency domain associated with adaptable capacity, which has been recognized as one of the most efficient method to address the non-stationary signals. In this study, Matlab software was used as the calculation code and field millisecond delay blasting data was collected as the research objects, the Hilbert time–frequency spectrum, marginal spectrum, instantaneous energy spectrum and Hilbert energy spectrum scatter were obtained for the signal IMF components under the standard instfreq.m function (as shown in Section 3.3) frequency modulation with the identified bandwidth of 1 Hz. The reasons of negative frequency for digital signals were discussed based on the theoretical analysis and the digitial signals were then summarized as two types of negative frequency according to the instantaneous phase characteristics. The field collected blasting vibration signals were used to illustrate the features of the negative frequency points such as large number, correlated relation between the signal amplitude extent and frequency band, and non-negligible of the total vibration energy. In addition, a theoretical equation was proposed for the instantaneous phase optimization function based on the HHT method, and a triple identification approach of millisecond time was proposed based on instantaneous phase optimization method. The process of Hilbert spectrum analysis based on HHT instantaneous phase optimization was implemented using Matlab, which was used to analyze Hilbert spectrum characteristics. Further, a theoretical comparison and analysis between the standard instfreq.m time–frequency modulation and the proposed phase optimized HHT spectrum were performed, and the results shows that the optimized HHT spectrum analysis improves the accuracy of time–frequency spectrum and Hilbert spectrum calculation, besides, the frequency domain recognition width is about 2∙r times of that from the standard solution. Finally, the phase optimization was used to analyze the amplitude spectrum, instantaneous velocity energy spectrum and 3D time–frequency seismic velocity energy spectrum features, application of HHT-based instantaneous phase optimization method is given for the accurate recognition application of multi-segment detonation millisecond time in underground blasting.

Study on Analysis of Structural Strong Motion Records Based on HHT

Stochastic seismic responses analysis of long-span rigid-framed bridge with high piers considering travelling wave effect

Identification of Earthquake Ground Motion Based on Limited Acceleration Measurements of Structure Using Kalman Filtering Technique

Study on the Method of EMD-Based Vibration Signal Time-Frequency Analysis

Seismic Structural Damage Detection Based on Time Frequency Response Function

HHT method for system identification and damage detection: an experimental study

Ground Motion and Site Characteristics Evaluation Using Hilbert-Huang Transform Method Based on Light-Moderate Earthquakes

Study on EMD method in strong motion record processing application

Application of Three Transformations in the Analysis of in Strong Earthquake Records

Structural Time-Varying Parameter Analysis Based on Adaptive System Identification Method Using Strong Motion Records

Bizarre Waveforms in Strong Motion Records

Application of Hilbert-Huang Transform in Structural Health Monitoring: A State-of-the-Art Review

Evaluation of earthquake-induced structural damages by wavelet transform

Spectrum characterization and assessment method of long-periodic ground movements

Improvements in the HHT for the Modal Parameter Identification of Structures with Closely Spaced Modes

Structural Modal Analysis Based on HHT and Butterworth Filter

Time-varying modal identification of structures under seismic excitations using a novel time-frequency method

Modal parameter identification for engineering structures based on HHT method

Preliminary analysis on bizarre waveforms in strong motion records

Time-frequency analysis of Transitory/Permanent frequency decrease in civil engineering structures during earthquakes

Hilbert spectrum analysis method of blast vibration signal based on HHT instantaneous phase optimization