Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Mechanism analysis of viscoelastic interfacial instability of polymer multiphase processing

Numerical Simulation on Interfacial Instability of Polymer Multiphase Processing

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Three-Dimensional Roll-Up of A Viscoelastic Mixing Layer

Simulation of Stress Distribution Near Weld Line in the Viscoelastic Melt Mold Filling Process

A Three-Dimensional Thermal Model for Viscoelastic Polymer Melt Packing Process in Injection Molding

Numerical Simulations of the Richtmyer-Meshkov Instability of Solid-Vacuum Interface

Instabilities of Marangoni and elasticity in a molten polymer film

Effects of convective schemes and geometric reconstruction scheme on interface of multiple melt flows

Numerical Investigation of the Effect of Viscoelasticity on Drop Retraction and the Evaluation of Interfacial Tension Between Polymer Melts

Numerical simulations of elastic-plastic Richtmyer-Meshkov instability of multiple interfaces

Simulation of dispersed phase evolution for immiscible polymer blends in injection molding

Multiplex vortex instability in the flow of non-Newtonian fluids through microcavity arrays

Emergence and Growth Dynamics of Wetting-induced Phase Separation on Soft Solids

Evolution of Concentration Fluctuation During Phase Separation in Polymer Blends with Viscoelastic Asymmetry

Marangoni Interfacial Instability Induced by Solute Transfer Across Liquid-Liquid Interfaces

Diffuse-interface simulations of drop coalescence and retraction in viscoelastic fluids

A rheological model for the interface of immiscible polymer melt in blending process

Role of Viscoelasticity in Non-Equilibrium Steady States of Sheared Entangled Polymer Mixtures

A semi-numerical algorithm for instability of compressible multilayered structures