BASIC ANALYSIS ON 1+3/2 AND 1+1/2 COUNTER-ROTATING TURBINES

Lu-Cheng JI
DOI: https://doi.org/10.3321/j.issn:0253-231X.2007.z1.029
2007-01-01
Kung Cheng Je Wu Li Hsueh Pao/Journal of Engineering Thermophysics
Abstract:In order to understand the performance and the range of application of two types of Vaneless Counter-Rotating Turbines (namely 1 + 1/2 and 1 + 3/2 stages VCRT) and then help making decision in engine design, the two types of VCRT are analyzed in terms of work speed ratio. The performance comparison of these two types of VCRT reveals many useful results. In all ranges of shaft speed ratio, the high efficiency region in work speed ratio of 1 + 3/2 stages VCRT is narrower than 1 + 1/2 stages VCRT, but the high efficiency region of 1 + 3/2 stages VCRT is always located in range of lower work speed ratio. As compared with 1 + 1/2 stages VCRT, 1 + 3/2 stages VCRT has a lower shaft work ratio, and can provide much more work. Shaft speed ratio (high pressure shaft over low pressure shaft) itself also exerts great influences on the efficiency and the application range of these two types of VCRT. As the absolute value of shaft speed ratio increases, high efficiency region always moves to the region with a higher total work speed ratio, and the shaft work ratio will also increase. All these results are used for reference in selecting turbine configurations in design of advanced aero engines.
What problem does this paper attempt to address?