Counter-rotating Compressor Flow Mechanism and Aerodynamic Design
ZHAO QingJun,ZHOU XiaoYong,ZHAO Wei,XU JianZhong
DOI: https://doi.org/10.1360/sst-2020-0088
2020-01-01
Scientia Sinica Technologica
Abstract:Improving the stage pressure ratio of compression components by reformatting the aerodynamic configuration is an important way to improve the thrust-weight ratio of aeroengines. Counter-rotating compressors improve the stage pressure ratio and reduce the axial length and weight of compressors. At present, counter-rotating compressors with high stage loading, high efficiency, and wide stable operating range are being developed. This paper presents an analysis on the elementary stage of a two-stage highly loaded single-rotor compressor, a 1+1 counter-rotating compressor, a conventional 1/2+1 counter-rotating compressor, and a counter-rotating ram compressor. The aerodynamic parameters and the mechanism of improving the stage loading of counter-rotating compressors are revealed. Adopting negative pre-swirl and high tip speed is an effective means to improve the power capability of the high-pressure rotor. The through flow and 3D aerodynamic design for the single-rotor compressor, the 1+1 counter-rotating compressor, the conventional 1/2+1 counter-rotating compressor, and the counter-rotating ram compressor with the same mass flow and inlet hub ratio are completed. For the above compressors, the pressure ratios are 3.0, 3.0, 3.0, and 5.0, respectively, and the average stage pressure ratios are 1.73, 1.73, 1.73, and 2.24 respectively. The inlet relative Mach numbers of the high-pressure rotor reach 1.18, 1.02, 1.40, and 1.88, respectively. The flow field characteristics of the high-pressure rotors of the above compressors with different inlet flow conditions are analyzed. The internal flow loss mechanisms of the high-pressure rotor of the counter-rotating ram compressor are analyzed. Results show that the main loss sources of the high-pressure rotor are the boundary layer separation caused by shock and the tip leakage flow. In consideration of the main loss sources of the high-pressure rotor, the design method of blade passage contraction ratio and reversely turning blade is proposed. This method suppresses the boundary layer separation caused by the terminal shock. The design method of blade local negative curvature is proposed, and it suppresses the boundary layer separation caused by the leading edge shock. Moreover, the design method of end-wall curved blade is established, and it reduces the intensity of tip leakage flow. These methods effectively improve the efficiency of the high-pressure rotor of the counter-rotating ram compressor. The starting method of the high-pressure rotor based on adjusting the throat area and the casing bleeding near the throat is established to overcome the performance degradation of the counter-rotating ram compressor under off-design conditions. With these methods, the lowest starting speed of the counter-rotating ram compressor can be reduced to 40% design speed. The aerodynamic performance of the counter-rotating ram compressor at medium and low speeds is improved.