Abstract:This paper describes a comparator capable of detecting mV-range input voltage signals reliably using sub-nW power consumption. The comparator uses a current-mirror-based positive feedback and hysteresis to generate the mV-range threshold. It has three new ideas: (1) to use the input signal to bias the current mirror, which only activates the current mirror when the input signal reaches a detectable threshold; (2) to achieve dynamically controllable detectable threshold by using control signals to adjust the mirror transistor sizes; and (3) to use negative feedback to compensate the process-voltage-temperature variation. Preliminary SPICE simulation results using state-of-the-art 9HP (BiCMOS) have shown that the proposed hysteresis-based comparator can achieve the following performance metrics: 1) Very low comparator threshold (in the range of mV); furthermore, these threshold voltages can be programmable at run-time from a few to tens of mV. 2) Steep equivalent subthreshold slope in the range of sub-mV/decade. 3) Ultra-low leakage power (in the sub-nW range for a 0.1mV input voltage) and switching energy (in the nW range). The proposed hysteresis-based comparator only requires one standard logic supply source (working over 1V to 0.5V). Furthermore, initial simulations have shown that this comparator threshold is reliable over the process and voltage (PV) variations, and linearly proportional to temperature (T) variation.

Design of input module in non-magnetic metering chip with low power consumption

Design of Intelligent and Low-Power for Vortex Flow-Meter

A Low Power Continuous Time Hysteresis Comparator with an Average Current Consumption of 614na at 1.5 Voltage

Research of Low Power Consumption Intelligent Heat Meter

An Energy Metering Chip with a Flexible Computing Engine

An Electromagnetic Vortex Flowmeter with Low Power Consumption

Low Power Consumption Design of the Data Acquisition Node for 5-digit Directly Reading Gas Meter

Design of Low Power Handheld Meter Reading Terminal Based on S3C6410 and CLRC632

Design and Analysis of an Always-ON Input-Biased Pa-Current Sub-nW Mv-Threshold Hysteretic Comparator for Near-Zero Energy Sensing.

A Low Power Signal-Detector Design and Its Implementation for RFID Systems

A 0.2-Mv 20-Mhz 600-Μw Comparator

Ultrasensitive modulated magnetoelectric sensors and low noise readout circuits for DC and very low frequency weak magnetic signal detection

An Ultra-Low-power CMOS Temperature Sensor for RFID Applications

High precision MI sensor with low energy consumption driven by low-frequency Wiegand pulse

Design of Low Power Temperature Sensor Based on Full Resistance Frequency Domain Readout

A subthreshold ultra low power 22fJ/conversion flash ADC for RFID sensing applications

78 Nw Ultra-Low-power 17 Ks/s Two-Step-successive Approximation Register Analogue-to-digital Converter for RFID and Sensing Applications

Design of Ultra-Low-Power Electrocardiography Sensors

Data Collector with Ultra-Low Power Consumption Based on EM 78P 458 Single Chip Microprocessor

A low power demodulator using subthreshold design

A Low Power Cyclic ADC Design for a Wireless Monitoring System for Orthopedic Implants