Abstract:In this investigation, thin films of YbFeO 3 , both in its pure form and doped with 10% Co, were fabricated on a p -Si substrate at 500 °C through the radio-frequency magnetron sputtering method. Examination via Scanning Electron Microscopy demonstrated a porous texture for the pure sample, contrasting with a smooth and crack-free surface post-Co doping. Analysis via X-ray photoelectron spectroscopy unveiled Yb's 3 + oxidation state, alongside the presence of lattice oxygen, oxygen vacancies, and adsorbed oxygen evident in Gaussian fitting curves. Photoluminescence spectroscopy revealed an augmented emission intensity, likely attributed to increased defect initiation in the Co-doped specimen. Moreover, Raman spectroscopy was employed to identify vibration modes in the examined samples, demonstrating shifts in Raman peaks indicative of Co substitution and subsequent distortion in the crystal structure of YbFeO 3 . Electrical assessments were conducted at room temperature (300 K) under ambient conditions, employing voltage and frequency as variables. Capacitance–voltage measurements illustrated the emergence of an accumulation, with depletion and inversion regions manifesting at different frequencies based on the applied voltage, attributed to the YbFeO 3 interfacial layer at the Al and p -Si interface. The conductance-voltage characteristics indicated that the structure exhibited maximum conductance in the accumulation region. Series resistance for these configurations was deduced from capacitance-conductance-voltage measurements, indicating a dependence on both bias voltage and frequency. The doping process led to a reduction in capacitance and series resistance, accompanied by an increase in conductance values. After obtaining corrected capacitance and conductance parameters, it became evident that series resistance significantly influences both parameters. Interface state density ( N ss ), determined through the Hill-Coleman relation demonstrated a decreasing trend with increasing frequency. The pure sample exhibited higher interface state density compared to the Co-doped sample at each frequency, highlighting that the 10% Co-doped YbFeO 3 thin film enhances the quality of the metal–semiconductor interface properties compared to the pure contact.

Electronic Structure and Transport Properties of Doped Cosi Single Crystal

Electronic structure and transport properties of Co(Si1-xMx) (M = Al, P): First-principles study

First-principles Study of Electronic Structure for CoSi

Effects of Al Substitution for Si on Electronic Structure and Transport Performance of CoSi Single Crystal

Ab initio study of electronic properties of CoSi2 and NiSi 2 in the fluorite structure

A First-Principle Study of Electronic and Geometrical Structures of Semiconducting Β-Fesi2 with Doping

Effects of Al Doping on the Thermoelectric Performance of CoSi Single Crystal

DOPING EFFECTS IN YBa2Cu1-xCox(Cu1-yZny)2Oz SYSTEM

Effect of Co Doping on Superconductivity and Transport Properties in SmFe$_{1-x}$Co$_{x}$AsO

The spintronic and optoelectronic applications of substitutional doped CoS2

BAND STRUCTURE OF CoSi_2

First‐Principles Study on Electronic and Elastic Properties of Co, Ni, Cu, and Mo‐Doped Β‐Si3N4

Ab Initio Calculations of the Structural and Elastic Properties of CoSi 2

Structural Characteristics and Quantum Chemistry Calculation of Si-Doped Boron Carbides

<title>Ab initio study of electronic properties of CoSi<formula><inf><roman>2</roman></inf></formula> and NiSi<formula><inf><roman>2</roman></inf></formula> in the fluorite structure</title>

The aggregation phenomenon of impurity atoms in Si and the properties of C-doped Si studied by first-principle calculations

Electronic structure of amorphous silicon carbide compounds

Crystal growth and quantum oscillations in the topological chiral semimetal CoSi

Si-C Atomic Bond and Electronic Band Structure of a Cubicsi1−ycyalloy

Structural transitions, magnetic properties, and electronic structures of Co(Fe)-doped MnNiSi compounds

The electrical and dielectric features of Al/YbFeO3/p-Si/Al and Al/YbFe0.90Co0.10O3/p-Si/Al structures with interfacial perovskite-oxide layer depending on bias voltage and frequency