Abstract:In order to directly observe the conversion between guided-wave modes and leaky-wave modes in a periodic structure, quadrilateral periodic metal diaphragms arranged in two ways on metal surfaces were analyzed. In the first scheme, each unit cell in the periodic structure contains a metal diaphragm, of which the dispersion characteristics of periodic structures were analyzed by the finite element method. The results of the numerical simulation show that by adjusting lattice constants of periodic structures and geometrical parameters of metal diaphragms, the transmission bandwidth of the present 1-D periodic metal diaphragm structures could be limited to X-band, where the transmission characteristics are easy to be measured. In the second scheme, a pair of mirror-symmetric and staggered quadrilateral metal diaphragms is introduced into a unit cell. It can be found in the theoretical calculation that a new dispersion curve, which passes through the light line in a high frequency range, can be exhibited. The propagation constants of dispersion curves become complex numbers and provide highly directional electromagnetic radiation that scans as the frequency changes. After the relative positions of the two metal diaphragms were properly adjusted, the frequency range of the forbidden band gap between two dispersion curves can be minimized, so as to increase the transmission bandwidth of the 1-D periodic metal structures. The experimentally measured results show that the dispersion curves of the two periodic structures were highly consistent with the theoretical results. The narrowing of the band gap could be verified by measuring the $S$ -parameters. The near-field measurement of the periodic metal structures can demonstrate the conversion between the guided-wave modes and the leaky-wave modes, and the far-field measurement can show the frequency dependence of beam elevation. We expect that these artificial material structures could be widely used for designing new microwave and terahertz band devices.

Simulation And Fabrication Research On X-Band Photonic Band Gap Accelerating Structure

A Direct Near-Field Observation of Conversion Between Waveguide Modes and Leaky Modes in Periodic Metal Structures

Analysis of finite-size coated electromagnetic bandgap structure by an efficient scattering matrix method

Characteristics Modeling of Photonic Crystal by Using Numerical Techniques

Designing Wire Antennas in Metallic Photonic Bandgap Structures with an Explicit and Efficient Method

Design and Fabrication of a Planar Coupling Structure for Photonic Band Gap Devices

Fabrication, Tuning, and High-Gradient Testing of an X-band Traveling-Wave Accelerating Structure for VIGAS

Design, Fabrication, and High-Gradient Testing of an X -Band, Traveling-Wave Accelerating Structure Milled from Copper Halves

Extraordinary Transmission in Metamaterial-Loaded Waveguides: Effective-Medium Models, Microwave Experiments and Tight Binding Studies

Simulation Study on 104 MHz Radio Frequency Quadrupole Accelerator

Fabrication and high power rf test of a c-band 6MeV standing-wave linear acceleratingstructure

Existing conditions of full bandgaps and absolute negative refraction in metallic-dielectric photonic crystal

Band Structure Optimization of Superconducting Photonic Crystals Based on Transmission Spectrum Calculation.

Design, Fabrication and Cold-Test of an X-band Accelerating Structure for Linearizer

Novel Photonic Bandgap Structure And Its Application In Amplifier

Optimization Design and Fabrication of Photonic Crystal Waveguides Based on Soi Using 248-Nm Deep-Uv Lithography

Hybrid photonic-bandgap accelerating cavities

Design and Test of an X-band Constant Gradient Structure

Preparation of Electromagnetic Band-Gap Materials Using Low Temperature Co-Fired Ceramic Technique and Its Properties Study

Design,fabrication,and Testing of Low-Group-velocity S-band Traveling-Wave Accelerating Structure

Simulated calculation and design for fabricating three-dimensional photonic crystal structures using holographic lithography