Abstract:In this study, the nacre-like 2024Al/B4C composites with a lamellar-interpenetrated architecture, virtually free of pores and cracks, were fabricated through combining freeze casting with pressure infiltration, and their quasi-static and dynamic compressive properties were investigated over the temperature ranged from 25 to 500 °C. The dynamic compressive strength and strain were greater than quasi-static ones due to strain-rate hardening and adiabatic heating softening mechanisms. Regardless of strain rates, the compressive strength decreased with temperature, while the failure strain increased. This could be explained by four main fracture phenomena including cracking of B4C and intermetallic compounds (IMCs), matrix deformation and interfacial debonding. The matrix deformation prevailed actively at high temperatures, with a reduced overall trend towards cracking and interfacial debonding. The interfacial debonding and particle cracking acted as the dominant factors that deteriorated the compressive behavior, whereas the soften matrix induced by elevated test temperatures effectively blocked the crack propagation that favorably worked for the strain. As the temperature was raised, the softened matrix destabilized particle skeleton with the deformation behavior of the composites determined by the alloy matrix. However, recrystallization occurred within the alloy matrix, accompanied by a reduction in dislocation density, which degraded the strength of the composites. The elevated temperatures significantly enhanced the strain rate sensitivity of the composites because of the matrix softening yielding a greater proportionate enhancement of particle stress at high temperature than at low temperature.

Deformation And Fracture Behavior Of 7039 Al Reinforced With B4c Particles At Elevated Temperature

Influence of Zrc Content on the Elevated Temperature Tensile Properties of Zrcp/W Composites

Compressive behavior of high particle content B4C/Al composite at elevated temperature

Investigation on the High-Temperature Ductility and Fracture Mechanisms of an In-Situ Particle Reinforced Al Matrix Composite 7075Al/tib2

Elevated Temperature Compressive Deformation Behavior of 2024al Matrix Composite Reinforced by Sub-Micro Al2o3 Particles

Hot deformation behavior and microstructural evolution of particulate reinforced AA6061/B4C composite during compression at elevated temperature

Compressive deformation behavior of α-Si3N 4w/4032 Al composite at elevated temperatures

High Temperature Mechanical Properties and Wear Performance of B4C/Al7075 Metal Matrix Composites

High fatigue performance and microscopic mechanisms of in-situ TiB 2 /7050Al composite at different temperatures

Superplastic Behavior of Carbon Nanotube Reinforced Aluminum Composites Fabricated by Flake Powder Metallurgy

Compressive deformation behavior of alpha-Si(3)N(4)w/4032 Al composite at elevated temperatures

High temperature compression behavior of Al2O3 particle reinforced 6061aluminum alloy composite

Dynamic mechanical response and damage mechanisms of nacre-inspired 2024Al/B4C composite at elevated temperature

Compressive response and microstructural evolution of in-situ TiB2 particle-reinforced 7075 aluminum matrix composite

Deformation behavior and microstructure evolution of 7050 aluminum alloy during high temperature deformation

Temperature dependence of fracture behavior of in situ synthesized TiC/Ti-alloy matrix composite

Deformability of a SiCw/6061Al composite during high strain rate compression at elevated temperatures

Effects of particle volume fraction on dynamic deformation behaviors of B 4C reinforced aluminum matrix composites

Ductile Fracture Behavior of in Situ TiB2 Particle Reinforced 7075 Aluminum Matrix Composite in Various Stress States

Hot Deformation Behavior and Mechanisms of SiC Particle Reinforced Al-Zn-Mg-Cu Alloy Matrix Composites

Mechanical Property of M40J F /5a06al Composite at Elevated Temperatures