Abstract:One-dimensional (1D) Li+:TiO2 nanowires, Li4Ti5O12 nanotubes, and Li4Ti5O12 nanotube/graphene composite were prepared by using an electrospinning technique. The types and molecular weights of polymer templates and annealing rate have important effects on electrospun products. The Li4Ti5O12 nanotubes and the Li4Ti5O12 nanotube/graphene composite were obtained by heating at a rate of about 0.5 °C/min from a polyvinylpyrrolidone (PVP) template, while the Li+:TiO2 nanowires were obtained by heating at a rate of about 2 °C/min from a polyethylene oxide (PEO) template. Li4Ti5O12 nanotubes have an outer diameter of approximately 120 to 200 nm and their wall thickness is in the range of 30 to 40 nm. The morphology and size of the Li4Ti5O12 nanotube/graphene composite are similar to those of the Li4Ti5O12 nanotubes. The Li+:TiO2 nanowires have diameters in the range of 600-3000 nm. The crystal structure of the Li+:TiO2 nanowires was changed from anatase TiO2 to spinel Li4Ti5O12 with increasing Li+ dopant concentration. The electrochemical performance of the Li4Ti5O12 nanotubes, and Li4Ti5O12 nanotube/graphene composite for intended use in a lithium-ion battery (LIB) was investigated and compared with that of the TiO2:Li+ nanowires. The Li4Ti5O12 nanotube/graphene composite specimen exhibits the highest discharge specific capacities and cycle stability, which can reach initial capacity of 186.4 mAh·g-1, and remain at 175.0 mAh·g-1 after 100 cycles under a current density of 100 mA/g.

Preparation and Characterization of Lithium Aluminate Nanotube Bundles

Synthesis of MgO nanotube bundles

Hydrothermal routes to various controllable morphologies of nanostructural lithium aluminate

Hydrothermal Synthesis of Single Crystal Mesoporous LiAlO2 Nanobelts

Architectural Design and Phase Engineering of N/B-Codoped Tio2(B)/Anatase Nanotube Assemblies for High-Rate and Long-Life Lithium Storage

Hydrothermal Synthesis of Needle-Like Hyperbranched Ni(So4)(0.3)(Oh)(1.4) Bundles and Their Morphology-Retentive Decompositions to Nio for Lithium Storage

In situ study on bending modulus of Al2O3nanotubes prepared by atomic layer deposition

Hydrothermal Synthesis of Monodispersed LiMnPO4 (010) Nanobelts and [001] Nanorods and Their Applications in Lithium-Ion Batteries

Hydrothermal Synthesis of Monodispersed LiMnPO4 (010) Nanobelts and [001] Nanorods and Their Applications in Lithium-Ion Batteries: Hydrothermal Synthesis of Monodispersed LiMnPO4 (010) Nanobelts and [001] Nanorods and Their Applications in Lithium-Ion Batteries

Hydrothermal Synthesis of High Surface Area Mesoporous Lithium Aluminate

Electrochemical Properties Of 0.5li(2)Mno(3)Center Dot 0.5li(4)Mn(5)O(12) Nanotubes Prepared By A Self-Templating Method

A Simple Hydrothermal Method to Synthesise Highly Pure Hexagonal and Rhombus Alpha-Lialo2 Nanosheets

Electrochemical Properties of 0.5li2mno3·0.5li4mn5o12 Nanotubes Prepared by a Self-Templating Method

Electrochemical performance of 0.5li2mno3 0.5lini0.5mn0.5o2 nanotubes prepared by a self-templating route

Synthesis And Characterization Of Boehmite Alooh Nanotubes

Preparation And Characterization Of Gamma-Alooh Nanotubes And Nanorods

Production Of Large Area Carbon Nanotube Bundles On Metal Substrate

Structural characterizations and electronic properties of boron nitride nanotube crystalline bundles.

Self-templating synthesis of single crystalline LiNi0.5Mn1.5O4 nanotubes with improved electrochemical performance

Effect of Alkalinity on the Hydrothermal Synthesis of Li2zro3 Nanotube Arrays

Preparation of Li+:TiO2 nanowires, Li4Ti5O12 nanotubes, and Li4Ti5O12 nanotube/graphene composite by single-spinneret electrospinning for application in a lithium-ion battery