Abstract:A series of nonlinear characteristics, such as strain softening, elastic–plastic coupling, and plastic deformation failure, have focused attention on postpeak deep rock masses. However, one-dimensional models, such as the Mohr–Coulomb (M–C) and strain-softening (SS) models, do not consider the influence of confining pressure, which can increase inaccuracies when used for simulating rock deformation in deep underground engineering. In this study, the composite effect of plastic damage accumulation on the mechanical properties of surrounding rock under different confining pressures was investigated through triaxial cyclic loading–unloading tests. A two-dimensional mechanical model for the cohesion, friction angle, elastic modulus, and dilatancy angle was developed by considering the combined effect of the confining pressure and plastic shear strain. The results showed that the cohesion and friction angle could be determined using an exponential function and a line function, respectively, with plastic deformation and confining pressure. The correlation coefficient of the two-dimensional function reached 95%. The elastic modulus increased with the confining pressure as a negative exponential function but decreased with the plastic deformation as a linear function. The dilation angle linearly decreased with the confining pressure and first increased and then decreased with the plastic deformation, which could be determined by the difference between two exponential functions. Through the use of FLAC3D software, the strain-softening model developed in this study was used to simulate a triaxial rock compression test, and the result demonstrated that the modified model was accurate and reasonable.

Multi-scale elasto-plastic calibration of the regression analysis of 3D initial crustal stress field

Influence Analysis of In-situ Stress on Plastic Zone of Circular Chamber Surrounding Rock

Incremental behavior of granular soils: a strain response envelope perspective

DDM Regression Analysis of the In-Situ Stress Field in a Non-Linear Fault Zone

An Elastic-Viscoplastic Model for Time-Dependent Behavior of Soft Clay and Its Application on Rheological Consolidation

Numerical Modeling of the Effect of Strain Rate on the Stress-Strain Relation for Soft Rock Using A 3-D Elastic Visco-Plastic Model

Study on Fitting Analysis of Initial Stress Field in Rock Masses

A three-dimensional elastoplastic constitutive model incorporating Lode angle dependence

A novel anisotropic deterioration mechanical model for rock ductile–brittle failure under 3D high-stress and its application

Numerical Modeling of the Constitutive Relationship of a Soft Rock Using a 3-D Elastic Visco-Plastic Model

Quantification of full-field stress in continuously loaded fractured rocks using 3D printing and digital photoelasticity

An experimental investigation and mechanical modeling of the combined action of confining stress and plastic strain in a rock mass

Effect of Intermediate Principal Stress on Strength of Soft Rock under Complex Stress States

Elasto-plastic Analysis of the Surrounding Rock Mass in Circular Tunnel Using a New Numerical Model Based on Generalized Nonlinear Unified Strength Theory

Three Dimensional FE Regression Analysis of Multivariate Geo-stress Field of Muzhailing Tunnel

Characteristics of elasto-brittle-plastic softening constitutive theory and its numerical calculation

On the solution of limit load and reference stress of 3-D structures under multi-loading systems

Research of Crustal Stress Simulation Using Finite Element Analysis Based on Corner Point Grid

Nonlinear Visco-Elasto-Plastic Model for Surrounding Rock Incorporating the Effect of Intermediate Principal Stress

Slope stability analysis based on a multigrid method using a nonlinear 3D finite element model

A Novel Numerical-Iterative-approach for Strain-Softening Surrounding Rock Incorporating Rockbolts Effectiveness and Hydraulic-Mechanical Coupling Based on Three-Dimensional Hoek-Brown Strength Criterion