Abstract:This paper investigates mechanisms of the surface charge dissipation of silicone rubber (SiR) after dielectric barrier discharge (DBD) plasma treatments in an open air. Electrical and physicochemical properties of the untreated and plasma treated samples were evaluated by surface and volume conductivity, surface potential decay (SPD) measurements, Fourier transform infrared (FT-IR), and water contact angle tests. Results show that the surface conductivity of the plasma treated samples evidently increases with the treatment time. The samples with a longer DBD plasma treatment time enhance the SPD rate after the positive and negative corona charging. However, an abnormal surface potential variation is observed at the beginning of the SPD after the negative corona charging. It is found that the top-bottom surface plasma treatment can further accelerate the SPD of the samples compared with the untreated and single surface plasma treated samples. The physicochemical analysis shows that the concentration of polar groups is increased after the plasma treatment, and the water contact angle is consistently declined with the increase of the plasma treatment time. The calculated trap distribution illustrates that the hole trap energy and the electron trap density of the sample are decreased after the plasma treatments. This investigation attributes the measured SPD of the untreated sample and single surface treated samples to the electrical conduction along the sample surface, but the SPD of the top-bottom surfaces plasma treated samples is enhanced by the charge neutralization and transportation through the material bulk as well as the sample top surface conduction.

Study of improvement of graft and dyeability of linen by air DBD plasma surface treatment

Development of Universal Fabric Dyeing and Adhesion Through RF Glow Discharge Plasma Treatment

Influence of DBD Treated Nano‐al2o3 on Thermal and Electrical Insulation Properties of Epoxy Nanocomposites at High Temperatures

The Investigation of the Treatment of Dyeing Wastewater by Galvanic Corrosion-Reduction Degradation-Coagulation Absorption

Surface Modification by the DBD Plasma to Improve the Flame-Retardant Treatment for Dyed Polyester Fabric

Surface Treatment by Dielectric Barrier Discharge with Wire Mesh Electrodes

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Surface Modification and Mechanical Properties Improvement of Bamboo Fibers Using Dielectric Barrier Discharge Plasma Treatment

Effect of Atmospheric Pressure Plasma and Subsequent Enzymatic Treatment on Flax Fabrics

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Modification of terylene fabric by homogeneous discharge in air at atmospheric pressure

Application of Bipolar Pulsed Power to ADBD and Terylene Surface Modification

Experimental Study of Accelerating Surface Charge Dissipation on Polymer Treated by Repetitively Pulsed Discharge Plasmas

Characteristics of Unipolar Nanosecond Pulse DBD andIts Application on Surface Treatment of Polyimer Films

Degradation And Discoloration Of Textile Dyes Using Gliding Arc Plasma Combined With Fenton Catalysis

Atmospheric Air Homogenous DBD Plasma Excited by Bipolar Nanosecond Pulse Used for Improving the Hydrophilic Property of Polypropylene

Surface charge dissipation and DC flashover characteristic of DBD plasma treated epoxy resin/AlN nanocomposites

Study on Generation of Glow Discharge Plasma in Air and Surface Modification of Wool Fabric

Surface activation of viscose textiles via air, argon, and oxygen dielectric barrier discharge plasma: Influence of peak voltage

Effects on Surface Properties of Natural Bamboo Fibers Treated with Atmospheric Pressure Argon Plasma

Effect of Atmospheric Pressure Plasma Treatment/Followed by Chitosan Grafting on Antifelting and Dyeability of Wool Fabric