Abstract:Dielectric barrier discharge (DBD) is proved to be an effective method for surface treatment of polymers over the past 20 years and is now widely used in the fields of surface modification. In this paper, surface treatment of polyethylene terephthalate (PET) films for improving the hydrophilicity using DBD excited by unipolar nanosecond pulses is presented. Two typical discharges exhibiting homogeneous and filamentary modes are obtained under certain experimental conditions, and then, they are used to modify the surface of PET films. The microstructure and properties of the film surface before and after treatment are characterized with water contact angle measurement, scanning electron microscope, atomic force microscope, and X-ray photoelectron spectroscope. The results show that, with the treatment power density of 192 and 158 mW/cm(2) in filamentary and homogeneous modes, respectively, surface morphology and property after treatment are significantly changed, and the physical etching and introduction of oxygen-containing polar functional groups account for the decease of surface contact angle and the increase of surface roughness. Compared with the filamentary DBD treatment, the homogeneous DBD (HDBD) is more effective in surface treatment, such as lower contact angle, higher roughness, and more oxygen-containing function groups after treatment. It is attributed to the fact that the HDBD can achieve a uniform treatment and can make the physical and chemical interaction much sufficient.

Application of Bipolar Pulsed Power to ADBD and Terylene Surface Modification

Characteristics of Unipolar Nanosecond Pulse DBD andIts Application on Surface Treatment of Polyimer Films

Influence of DBD Treated Nano‐al2o3 on Thermal and Electrical Insulation Properties of Epoxy Nanocomposites at High Temperatures

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Surface Modification of Polyimide Films Using Unipolar Nanosecond-Pulse DBD in Atmospheric Air

Rapid Disinfection Performance of a Touchable Pulsed SDBD Nonthermal Plasma

Surface Treatment of Polyethylene Terephthalate Films Using Dbd Excited by Repetitive Unipolar Nanosecond Pulses in Air at Atmospheric Pressure

Improved Surface Modification of Polymer Films by Energy-Compressed Dielectric Barrier Discharge with Discharge-Time-Regulated Power Source

Surface Treatment by Dielectric Barrier Discharge with Wire Mesh Electrodes

Modification of terylene fabric by homogeneous discharge in air at atmospheric pressure

A Comparative Study of Water Electrodes Versus Metal Electrodes for Excitation of Nanosecond-Pulse Homogeneous Dielectric Barrier Discharge in Open Air

Experimental Study of Accelerating Surface Charge Dissipation on Polymer Treated by Repetitively Pulsed Discharge Plasmas

Experimental research of diffuse bi-directional pulsed dielectric barrier discharge plasma

Uniform of Unipolar Nanosecond Pulse DBD in Atmospheric Air

Surface Treatment of PET and PP by Atmospheric Pressure Dielectric Barrier Discharge for Improvement in Hydrophilicity

Characteristics of Nanosecond-pulse Dielectric Barrier Discharge in Atmospheric Air

Polypropylene Surface Plasma Modification Using Middle Frequency Power Supply

Study of Homogeneous DBD with Fine Wire Meshes and PET Films in Air at Atmospheric Pressure

Characteristics of annular surface dielectric barrier discharge with microsecond pulse under water-covered condition

The effect of air plasma on barrier dielectric surface in dielectric barrier discharge

Comparison of AC and Nanosecond-Pulsed DBDs in Atmospheric Air