Abstract:The thin-walled curved-surface component is an important structural element in aerospace. Wrinkling, springback and thermal distortion occur easily when forming these components. To form thin-walled components with high precision and strength, a two-layer-sheet hot-forming–quenching integrated process was proposed, in which wrinkling is prevented by thickening the upper sheet and springback is reduced by solution and die quenching. Selecting an appropriate upper sheet is crucial to suppress wrinkling and accomplish effective die quenching. The effect of the upper sheet on the wrinkling and strengthening behaviors of an Al–Cu–Mg-alloy melon-petal shell was thus studied in detail. The anti-wrinkle mechanism was analyzed through numerical simulation. The forming quality, including forming precision, deformation uniformity and strength, were further evaluated. The wrinkle gradually decreased with the increasing thickness of the upper sheet, resulting from the depressed compressive stress at the edge of the target sheet. A defect-free specimen with a smooth surface was finally formed when the thickness of the upper sheet reached three times that of the target sheet. The profile deviation was ±0.5 mm. Excellent thickness uniformity in a specimen can be obtained with a maximum thinning rate of 6%. The full strength, ranging from 455 to 466 MPa, can be obtained in all regions of the specimen, indicating that effective strengthening can be accomplished with the two-layer-sheet die quenching. The results indicated that high forming quality and full strength can be obtained in a two-layer-sheet hot-forming–quenching integrated process. This research has great potential for engineering applications using aluminum-alloy curved-surface thin-walled components.

Integral Forming for Special-Shaped Curved Surface Shell Parts of Turbofan Engine

Viscous Pressure Forming for Aluminum Alloy Bowl-Type Parts of Turbofan Engine

Form of Circumferential Weld-Induced Imperfections for Tapered-Wall Cylindrical Shell Structures

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Influence of Process Parameters on Thinning Ratio and Fittability of Bellows Hydroforming

Viscous Pressure Forming (vpf): State-Of-The-Art and Future Trends

Study on Whole Forming Process of Unequal Thickness Inner Liner for High-Pressure Gas Cylinder

Study on forming process of equal wall thickness metal spiral pipe by single screw pump

Spiral forming and cross-section deformation behaviors of finned special-shaped tube

An Enhanced Flow-Thermo-Structural Modeling and Validation for the Integrated Analysis of a Film Cooling Nozzle Guide Vane

Application of incremental forming in manufacturing of complicated thin-walled workpiece

Developments and perspectives on the precision forming processes for ultra-large size integrated components

Finite Element Analysis and Experimental Study of an Electromagnetic Shell Part with Flow Control Forming

Tc4 Deep Cylinder with Uniform Thickness by Friction-Changing Direct-Reverse Superplastic Forming

Wrinkling and Strengthening Behaviors in the Two-Layer-Sheet Hot-Forming–Quenching Integrated Process for an Al–Cu–Mg-Alloy Thin-Walled Curved-Surface Shell

A Hybrid Flexible Sheet Forming Approach towards Uniform Thickness Distribution

Numerical simulation and experiment research on forming of hollow blade with 304 stainless steels and Ti–6Al–4V tubes by sand mandrel

Optimization for the Forming Process Parameters of Thin-Walled Valve Shell

An Innovative Deep Drawing Process of Thin Curved Shells with Positive Local Bulging

Numerical Simulation and Process Improvement of a Typical Car Thread Plate