Abstract:To study seismic behavior of concrete-encased composite columns with unsymmetrical steel cross-sections, cyclic loading tests were carried out on 12 columns with L-shaped section steel. The test parameters included shear span ratio, axial compression level, stirrup ratio and presence of cross tie. Mechanical process, failure mode, hysteretic characteristics, skeleton curves, ductility and energy absorption capacity were taken into comparison. The result indicates that concrete-encased composite columns with unsymmetrical steel section possess good seismic performance under constant axial compression and cyclic horizontal load. The failure mode contains bending failure, shear-bond failure, shear compression failure and shear-composition failure. Unsymmetrical phenomenon of positive and negative hysteresis loop is shown evidently. Span ratio has a great influence on failure mode and shear-composition failure usually takes place in columns with L-shaped steel section. The ductility performance decreases with increasing of axial compression level, which is more obvious for columns with L-shaped steel section. As stirrup ratio increases, ductility and bearing capacity of columns are improved greatly, and energy absorption capacity after yielding is enhanced. However, these improvements are not evident for L-shaped steel section columns with smaller span ratio. Cross tie can enhance ultimate bearing capacity, and lower strength attenuation and stiffness degradation on the later loading stage, which enhances deformation capacity of L-shape steel section columns greatly.

Experimental Research on Steel Reinforced Ultra High-Strength Concrete Short Columns in Seismic Performance

Experimental study on seismic performance of ultra high-strength concrete short columns

Flexural-Shear Behavior of High-Strength Concrete Short Columns

Low Cyclic Fatigue Performance of Concrete-Filled Steel Tube Columns

Experimental Research on Eccentric Compressive Performance of Steel Tube-Reinforced Concrete Column

Dynamic Analyses of Steel-Reinforced Super High-Strength Concrete Columns

Experimental investigation of concrete-filled steel tubular columns with reinforcing lattice angle

Experimental Study on Seismic Behavior of High-Strength Concrete-Filled Steel Tube Composite Columns

Experimental study on the seismic performance of composite columns with an ultra-high-strength concrete-filled steel tube core

Numerical Research on Axial Compression Behavior of L-shaped Steel Reinforced Concrete Short Columns

Study on Axial Compression Ratio Limit Values of Steel Reinforced High-strength Concrete Columns

Experimental Study on Seismic Behavior of Concrete Filled Square Steel Tubular Columns to Low-Cycle Reversed Horizontal Load

Seismic Behavior of Concrete Columns with CRB735 High-Strength Steel Reinforcement

Seismic Behavior of Ultra-High Performance Concrete Short Columns Confined with High-Strength Reinforcement

The Limited Values of Axial Compression Ratio of Steel Reinforced High- Strength Concrete Short Columns

EXPERIMENTAL RESEARCH ON CONCRETE-ENCASED COMPOSITE COLUMNS WITH L-SHAPED STEEL SECTIONS

Experimental Study on Seismic Behavior of Concrete Columns with Central Reinforcement

Axial compression performance of ultra-high-strength concrete filled steel tubular lattice short columns

Experimental and Simulation Studies on the Seismic Performance of I-section Steel-Concrete Composite Columns

Experimental behaviour of high performance concrete-filled steel tubular columns

Experimental study on the seismic performance of beam-to-column composite connections in medium-high strength steel frame structures