Abstract:This paper is focused on a dual-loop current control method (grid current loop and fundamental current loop) for digitally controlled LCL-type shunt active power filters (APFs). Normally, a proportional-resonant (PR) unit is used as the fundamental current controller, where the proportional part of PR unit actually serves as the proportional feedback of inverter-side current and provides a certain degree of damping for LCL resonance. However, its valid damping region is only up to one-sixth of the sampling frequency (fs/6), which leads to less robustness to the grid impedance. To address this issue, a delay-compensation control link is proposed in this paper to replace the proportional part of the PR fundamental current controller and widen the effective damping region. As a result, the system robustness is improved without adding extra sensors or introducing an extra active damping loop. Theoretical analysis proves that it can obtain a wider damping region of (0, fs/4). Moreover, a systematic controller parameter design criterion is studied. In particular, a numerical optimization algorithm is developed to optimize damping property, and a design method based on root locus plot and Bode diagram is presented to enhance harmonic compensation accuracy. Finally, experimental results implemented on a 30 kVA APF prototype have validated the feasibility of the proposed current controller and parameter design criterion.

A family of control methods for parallel active power filters based on current detection

Analysis of the Control Strategies of Parallel Active Power Filter

Study of PAPF Control Method Based on P-Q Instantaneous Power Theory

Research on PI and Repetitive Control Strategy for Shunt Active Power Filter with LCL-filter

A Current Control Method for LCL Active Power Filters Based on the Reduced Order Generalized Integrator

A Robust Dual-Loop Current Control Method with a Delay-Compensation Control Link for LCL-Type Shunt Active Power Filters

A Systematic Approach Via IIR Filters for Enhancing the Robustness of LCL-Type Shunt Active Power Filters to Grid Impedance

Current Control of LCL-Type Shunt APFs: Damping Characteristics, Stability Analysis, and Robust Design Against Grid Impedance Variation

Comparison Of Control Strategies For Active Power Filter In Three-Phase Four-Wire Systems

Application of repetitive control for APF

A simple method of realization of low power loss and high compensation-precision active power filter

Design and implementation of compound current control strategy for improved LCL-based Shunt Active Power Filter

Design of the Repetitive Control Method for Active Power Filter

Control Strategy of Multi-modular Active Power Filter System

A waveform control technique for high power Shunt Active Power Filter based on repetitive control algorithm

A three-phase four-wire three-level active power filter based on one-cycle control

A current source with one-cycle control and its application in serial hybrid active power filter

Control Techniques for Active Power Filters

High precision compensation for high power Hybrid Active Power Filter based on repetitive control algorithm

Control Strategy for Shunt Active Power Filters with High Compensation Precision

A Compensation Strategy for Parallel System of Modular Active Power Filter Based on Real-time Average Current