Abstract:Current controllers are used in shunt active power filters to enhance the performance of electrical power systems by improving power quality and energy efficiency. Nonlinear current controllers are preferred in systems with nonlinear and dynamic loads due to their robust and rapid tracking of varying reference currents. Within this category, reference-based one-cycle current controllers feature fixed switching frequency and quasi-instantaneous reference current tracking. When compared to implementations based on classical one-cycle controllers (OCC), they enable tracking any desired reference current while maintaining cycle-by-cycle control. They are suitable for selective harmonic filtering, as well as source current balancing and reactive current compensation. However, these controllers have shown stability problems caused by the switching function alignment – even when symmetrical centred alignment is employed. To address these challenges, this work proposes a generalized reference-based one-cycle current controller. This new controller algorithm introduces two degrees of freedom in the formation of the switching signal and achieves stability, zero integral-current-error, and the selection of the final current value at the end of each switching cycle. The effectiveness of the proposed algorithm is validated through simulations and experimental results obtained from a three-leg four-wire shunt active power filter setup. A performance comparison is made between the new algorithm and previous approaches. The results demonstrate that the proposed controller achieves superior power quality indices by reducing the current harmonic distortion and approaching unity power factor.

A current source with one-cycle control and its application in serial hybrid active power filter

A new serial hybrid active power filter using controllable current source

High-Performance Resonant Controller For Active Power Filter With Selective Harmonic Compensation

A Current Control Method for LCL Active Power Filters Based on the Reduced Order Generalized Integrator

A Novel Control Approach for LCL-based Shunt Active Power Filter with High Dynamic and Steady-State Performance

Current Loop Control Approach for LCL-based Shunt Active Power Filter

A waveform control technique for high power Shunt Active Power Filter based on repetitive control algorithm

Design and implementation of compound current control strategy for improved LCL-based Shunt Active Power Filter

A three-phase four-wire three-level active power filter based on one-cycle control

Digital Generalized Integrators of Current Control for Three-Phase Active Power Filter with Selective Harmonic Compensation

A Double-Loop Current Control Strategy for Shunt Active Power Filter with Lcl Filter

Selective Harmonic Current Control Strategy Based on Frequency Adaptive Generalized Integrators

Generalized one-cycle current controller for improved SAPF power quality management

Design of DC-bus voltage controller for HAPF using low-pass filter

Study on Shunt Active Power Filter with High Quality Grid Current Waveform

High precision compensation for high power Hybrid Active Power Filter based on repetitive control algorithm

A New Hybrid Active Power Filter Topology with Continuous Compensation Bandwidth and Small Active Capacity

Shunt APF Control Strategy Based on Multiple Synchronous Rotating Transform

A Control Method for the Interleaved Active Power Filter with SiC-MOSFETs

Control Strategy for Shunt Active Power Filters with High Compensation Precision

New Hybrid Active Power Filter with Low Additive Reactive Current Injection