Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

Study on Modeling of the Roll Gap with Load for 4-h Mill

Shape and Crown Control Strategy for PC Mill

Simulation of Rolling Process on 4-High CVC Hot Strip Continuous Mills

Mathematical and numerical analysis of cross-directional control for SmartCrown rolls in strip mill

Research on Mathematical Model of Loading Roll Gap for Strip Temper Mill

THREE-DIMENSIONAL MODEL OF EQUIVALENT ROLL GAP OF CVC MILL UNDER CONDITIONS OF ROLL CROSSING AND NO LOAD

Simulation of the rolling process of 4-high hot steel strip continuous mills

Modelling of axial thrust force between rolls in strip mill

Analysis of Rolling Force Model in Cold Rolling Mill

Mathematical Models of Stable Roll Load of Double Stands Thin Gauge Strip Temper Mill

An Efficient Multi-Scale Modeling Method that Reveals Coupled Effects Between Surface Roughness and Roll-Stack Deformation in Cold Sheet Rolling

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Mathematical modeling and analysis of the tailor rolled blank manufacturing process

Finite Element Analysis of Contact Stresses on the Backup Roll of CVC Hot Rolling Mills

An improved method for calculating roll deformation of six-high rolling mill: enhances computation speed and accuracy

The central strain analytical modeling and analysis for the plate rolling process

Design of intermediate roll contour and analysis of regulation ability on strip shape of 18-High mill

ASR Bending Force Mathematical Model for the Same Width Strip Rolling Campaigns in Hot Rolling

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Research on the analytical model of rolling force for TiAl alloy pack rolling

Numerical Simulation Research on the Temperature Field and Hot Roll Crown Model of Hot Continuous Rolling Mills